ORTECH FRAME-1X4-BLP LED Panel Mounting Frames Kit Installation Guide
- May 15, 2024
- Ortech
Table of Contents
Instruction Manual
LED Panel Mounting Kit Frames
MODEL FRAME-1X4-BLP
FRAME-1X4-BLP LED Panel Mounting Frames Kit
WARNING
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
- Please keep the LED Panel Mounting Kit Frames away from any corrosive substance, and please use dry cloth when you clean it
- DO NOT use this LED Panel Mounting Kit Frame other than its intended purpose
- LED Panel Mounting Kit Frames can only be installed by a qualified electrician
- Please read this instruction manual thoroughly before installation
CAUTION
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR
FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a
competent electrician.
INSTALLATION GUIDE
Ceiling Installation
-
Screw A1 / A2 / B1 / B2 into a frame with screws
-
Then fix A1 / A2 to the ceiling with screws and remove B1 and two plastic clips
-
Insert the part of the lamp whose cover plate of the drive housing has been removed into the ceiling mounting profile. Connect the metal hose connector and the right angle connector
-
Knock out the knock hole on the drive cover plate, fix the metal hose right angle connector with the drive cover plate. Connect the power supply and the driver according to the wiring diagram after the circuit breaker is powered OFF
-
Place the lamp with the upper cover fully closed into the ceiling frame
-
Close the B1 connecting the two plastic corner clips and complete the installation
ORTECH reserves the right to modify at any time, without notice, any or all of our product’s features, designs, components and specifications to meet market changes.
[email protected]
www.ortechindustries.ca
13376 Comber Way Surrey BC V3W 5V9
205 Summerlea Rd
Brampton, ON L6T 4E5
1-888-543-6473
1-888-541-6474