ORTECH OE-316 LED Exit Signs Installation Guide

: May 15, 2024
: Ortech

Table of Contents

OE-316 LED Exit Signs
Application Notice
INSTALLATION GUIDE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LED Exit Signs
MODEL OE-316
Instruction Manual ORTECH OE-316 LED Exit Signs

OE-316 LED Exit Signs

WARNING
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY
A QUALIFIED ELECTRICIAN.

LED Exit Signs are for INDOOR USE ONLY
Please keep the LED Exit Signs away from any corrosive substance, and please use dry cloth when you clean it
LED Exit Signs can only be installed by a qualified electrician
Before installation or maintenance, please disconnect the power to prevent electric shock

Application Notice

All electrical connections MUST be in accordance with local codes, ordinances and the National Electric Code
Equipment should be mounted in locations and at heights where it will not be subjected to tampering by unauthorized personnel
The use of accessory equipment is not recommended by the manufacturer. DO NOT use the LED Exit Sign other than intended use
DO NOT mount in hazardous locations or near gas or electric heaters. DO NOT let power cords touch hot surfaces
Disconnect power at fuse or circuit breaker before installing or servicing
Allow battery to charge for 24 hours before first use

CAUTION
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a competent electrician.

INSTALLATION GUIDE

Mounting Instruction

THE FIXTURE IS SUITABLE FOR WALL, SIDE AND CEILING MOUNTING

Open front cover and assemble 2pc lamp heads on the frame
Knockout appropriate mount screw hole and cable hole, mount back plate on the wall after feeding building AC Supply Cable into back plate (see Fig.1)
For ceiling and side mounting purpose, remove the mounting hole cover on the top or side of unit, assemble the canopy (see Fig.3, Fig.5, and Fig.4)
Attach crossbar to junction box, set the longer blade of crossbar touching the J-Box
Route the proper wires through mounting hole out of housing
Make electrical connections inside the J-Box using the wiring diagram (see Fig.7)
Push excess wire into J-Box, use screws to tighten canopy to crossbar so canopy is securely fastened and tight against the wall
Attach battery connector to PC Board, restore front cover on unit, adjust position of lamp heads as needed
If pictogram direction assembled is not suitable, change pictogram direction or replace pictogram and then insert into diffuser (see Fig.6)

Fig.1 Assembly Lamp Heads

Open front cover by flat screwdriver
Insert the lamp heads at the corners of the main frame. Select direction of lamp head before inserting
Connect male connector on lamp head to female connector on PCBA

ORTECH OE-316 LED Exit Signs - heads Fig.2 Wall Mounting

ORTECH OE-316 LED Exit Signs - Connector Fig.3 Side Mounting Fig.4 Canopy Assembly
Insert canopy into housing at 20º and twist. Quick snap is now firmly locked.
CAUTION — Trying to remove canopy locked in place may cause damage.Fig.5 Ceiling Mounting Fig.6 Change direction of pictogram Fig.7 Wiring Diagram
Assembly Lamp Heads — AC WIRING Connect the WHITE wire to NEUTRAL. If using 120V, connect the BLACK wire to the hot lead.
if using 347V, connect the RED wire to the hot lead. Cap unused lead. ORTECH
OE-316 LED Exit Signs - Wiring Diagram ORTECH reserves the right to modify at any time, without notice, any or all of our product’s features, designs, components and specifications to meet market changes.