ORTECH WP40-3CCTW LED Wall Packs Instruction Manual
- May 15, 2024
- Ortech
Table of Contents
ORTECH WP40-3CCTW LED Wall Packs
WARNING
WARNING – THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
- LED Traditional Wall Packs are suitable for using in wet, dry, and damp locations
- Please keep the LED Traditional Wall Packs way from any corrosive substance, and please use dry or damp cloth when you clean it
- LED Traditional Wall Packs can only be installed by a qualified electrician
- Before installation or maintenance, please disconnect the power to prevent electric shock
Application Notice
- Do not exceed using the standard working voltage: 100-347V AC, 50/60Hz
- Be sure the power supply is turned off before installation
- Switch off power of the mains supply or the connection lead respectively before doing any works
- Please note waterproof, dustproof, electricity prevention and shockproof for the external power wires
- Be sure the connection between the wires is in good condition when installing the lamps, beware of leakage
CAUTION
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE
REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a
competent electrician.
INSTALLATION GUIDE
-
Remove the rubber plug.
-
Remove the screws from the top cover.
-
Open the lid.
-
Remove the reflector.
-
Fixed according to traditional installation method.
-
Connect the mains supply to the drive harness as shown in the figure, Adjust the CCT and power to the required gear.
-
Installing the reflector.
-
Install the cap screws and rubber plugs.
-
Installation completed.
CUSTOMER SUPPORT
info@ortechindustries.com
www.ortechindustries.ca
13376 Comber Way
Surrey BC V3W 5V9
205 Summerlea Rd
Brampton, ON L6T 4E5
1-888-543-6473
1-888-541-6474
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>