Quantek MUV4-HP-B Garage Door Remote Owner’s Manual

July 12, 2024
QUANTEK

Quantek MUV4-HP-B Garage Door Remote

GO/MUV Transmitter Programming

There are two methods for programming new transmitters from transmitters that are already programmed and working. If method 1 doesn’t work, please try method 2.
If neither work, please refer to the instructions of your receiver.
Note: It is also possible that your receiver could be securely managed by the installer or a management company, contact them directly if you believe this is the case.

Radio Programming (Method 1)

  1. Take a working transmitter and your new transmitters to within a few metres of the receiver.
  2. On the working transmitter, press both buttons simultaneously for 2 seconds (or the top 2 buttons if you have a 4 button remote).
  3. This puts the receiver into programming mode, you should hear a beep from the receiver.
  4. Within 10 seconds, press the top button on your new transmitter (you should hear a beep from the receiver).
  5. If you have multiple new transmitters to program, press the top buttons of each one after another, no need to repeat steps 1-3 for each.
  6. When finished, wait 10 seconds and you should hear 2 beeps from the receiver.
  7. Test your new remotes.

Side Programming (Method 2)

A = Existing Transmitter
B = New Transmitter to be programmed
Place both transmitters next to each other as shown on a non-metallic surface, a few metres away from the receiver.

  1. Press button 1 on transmitter A and keep it pressed down.
  2. Press down both buttons on transmitter B and keep them pressed until the LEDs flash 3 times.
  3. Press button 1 on transmitter B, the receiver will beep.
  4. Wait 10 seconds for the receiver to come out of programming mode; it will then be fully functional.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals