Quantek SQTXHELP-KIT Architrave Round & Single Gang User Manual

June 4, 2024
QUANTEK

Quantek SQTXHELP-KIT Architrave Round & Single Gang

Quantek-SQTXHELP-KIT-Architrave-Round-&-Single-Gang-product-
image

Architrave, Round & Single Gang Manual
Proximity switch for activation and access control
Hard coated, scratch resistant, anti-reflective, anti-microbial Steritouch acrylic label or Marine grade stainless.

ESnqutireare label is sensitive, Weatherproof
www.quantek.co.uk 01246 417113

Ascertain the fixing height
Use the back plate to mark cable hole and screw fixing points, round u nit can be angled towards approaching users.
Fi x the top retaining screw (No 8 or 10) leaving 4mm of screw shaft protruding.
Fit the back seal to the rear of back plate (if being installed externally)
Place the cable through back plate and make connections or connect battery clip and program to receiver.
Place the back plate in position, hook unit onto the top retaining screw and fit the bottom retaining screw.
NB: temporarily tape label on round unit to assess range, de power, remove adhesive backing and adhere label.

Architrave

Quantek-SQTXHELP-KIT-Architrave-Round-&-Single-Gang-03

Hardwired specification:

  • 12 – 28v dc
  • 8mA (standby) / 35mA (max) +18mA LEDs Sensitivity – Touch to hands free Selectable red, green, blue LEDs Sounder on activation
  • Timer 1 – 27 seconds
  • Latching function

Wiring diagrams
Hardwired sensor wiring. Alter LED colour configuration as required.

Quantek-SQTXHELP-KIT-Architrave-Round-&-Single-Gang-02 Quantek-SQTXHELP-KIT-Architrave-Round-&-Single-
Gang-01

Note: Never connect anything to RD terminal

Radio programming

Supply receiver with 12/24Vdc, power LED will light if powered correctly.
Wire relay outputs to activate terminals on the system (clean, normally open contacts).
Press and release the learn button, the learn LED will light up for 10 seconds Within the 10 seconds operate the touch sensor The learn LED will flash to confirm it has programmed.

Note: Standard touch sensors program to channel 1. The RX-T receiver will be required if you need to program them to different channels.
It is also possible to program our handheld and desk mount transmitters (CFOB, FOB-M, FOB4-M, DDA1, DDA2) into this receiver using the same method. See transmitter box for more details

Reset: To reset the receiver, press and hold the learn button for 10 seconds until the learn LED starts flashing. After this the memory will be deleted.

Radio specification

  • 868MHz
  • 4 x AA batteries
  • Approximately 100,000 operations Sounder & green LED on activation Battery saving design, unit will only activate once if hand left on.

Receiver specification

  • 12/24Vdc supply
  • 868MHz
  • 2 channels
  • 1A 24Vdc normally open contacts Momentary/bi-stable selectable relays 200 code memory
  • Dimensions: 65 x 50 x 30 mm

Quantek-SQTXHELP-KIT-Architrave-Round-&-Single-Gang-04

Dipswitch settings

| ON| OFF
1| CH1 ‐ Bi‐Stable| CH1 ‐ Momentary
2| CH2 ‐ Bi‐Stable| CH2 ‐ Momentary

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals