GALAXY AUDIO JIB/BT5R Wireless XLR Bluetooth 5 Receiver User Guide
- June 9, 2024
- GALAXY AUDIO
Table of Contents
GALAXY AUDIO JIB/BT5R Wireless XLR Bluetooth 5 Receiver
Other Helpful Sources
FAQ
-
Q. Can someone steal my Bluetooth® connection?
A. No, once the JIB/BT5R is paired with a Bluetooth® enabled device, other devices can not pair with it. -
Q. Is there a chance of interference with Bluetooth@?
A. There is always a chance of interference with any Bluetooth® connection. Bluetooth® is in the same frequency band as many cell phones and WiFi routers. These have higher outputs than Bluetooth® and can cause interference. -
Q. How far does the wireless connection reach?
Al This JIB/BT5R has a range over 300 feet (100 meters), under ideal conditions. -
Q. If I turn the JIB/BT5R off, will I have to reconnect my Bluetooth® device?
A. No, the JIB/BT5R remembers the last device it is paired with and will automatically reconnect. -
Q. Can I pause the music from my Bluetooth® device using the JIB/BT5R?
Al No, you must pause the music on your Bluetooth® enabled device.
Specifications subject to change without notice.
601 E. Pawnee Wichita, KS 67211 316. 263.2852 FAX 316.263.0642
www.galaxyaudio.com
Distributed in Canada by ADlpro.ca 1275 Newton, unit 6 Boucherville, QC J4B
5H2 Canada
450.449.8177 FAX 450.449.8180
Included Components
- JIB/BT5R x1 (x2 in dual system JIB/BT5RS)
- Micro USB Charging Cable x1 (x2 in dual system)
- Quick Start Guide x1
Single Receiver Operation
- On your Bluetooth® device, turn the Bluetooth® feature on.
- Flip the “POWER” switch on JIB/BT5R receiver to power on and begin pairing.
- The “Pair” LED will alternate flashing between blue and red when ready to pair.
- In your Bluetooth® enabled device, scan for devices and locate the JIB/BT5R. Tap it to connect to the receiver.
- When pairing is successful, the “PAIR” LED will remain blue.
Dual Receiver Operation
- To use two receivers as a stereo pair, first turn on both receivers.
- The “Pair” LED will alternate flashing between blue and red when ready to link.
- Press and hold both “STEREO-LINK” buttons for 2 seconds, when paired both will flash blue quickly for a few seconds
- One of the two receivers will now flash blue and red indicating it is ready to pair with your Bluetooth device
- In your Bluetooth® enabled device, scan for devices and locate the JIB/BT5R. Tap it to connect to the receivers.
Setup
-
Plug receiver into an active speaker, amp, or mixer.
-
When plugged into Mic level input, a pad switch can be flipped for appropriate sensitivities.
-
Play your music from your Bluetooth® enabled device. Note:
It is recommended to adjust the volume of devices in the following order: -
Adjust the Bluetooth® enabled device volume higher.
-
If using a mixer, first adjust the input channel levels and then its main output level.
-
The active Speaker/Amp should be the last volume adjustment.
-
To charge the receiver, plug the Micro USB Charger into the charging input. The receiver can remain plugged in for more long-term use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>