AViANCE 20702 Outdoor Hardwired Wall Lantern Installation Guide

AViANCE 20702 Outdoor Hardwired Wall Lantern

Product Specifications

• Model: HD56497
• Brand: AVIANCE
• Power Source: Electric
• Usage: Indoor
• Material: [Material Type]
• Color: [Color Options]

Product Usage Instructions

Assembling the Fixture

1. Shut off the power at the circuit breaker box.
2. Remove the old fixture.
3. Follow the instructions shown in Fig.1 to assemble the fixture.

Connecting the Wires

1. Connect the electrical wires as follows:
   • Connect the Black wire from the fixture to the black house (hot) Wire.
   • Connect the white wire from the fixture to the white (neutral) house wire.
   • Ensure all wire nuts are secured, and you may wrap the connections with electrical tape for added safety.
2. If your outlet box has ground wires (green or bare copper), connect the fixture’s ground wire to it. Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
3. Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Remember to return power to the junction box before testing the fixture.
Thank you for purchasing an AVIANCE product. For any further assistance with parts or assembly, please email customer service at: info@aviancelighting.net

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE

1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.

2. Thread the pipe screw part way into the center hole of the single bar and secure with a hex nut. Attach the single bar to the junction box using two box screws. The side of the single bar marked “GND” must face out. The junction box is not included.

3. Follow wiring instructions carefully(see fig.2).

4. Attach the lamp body onto the junction box, aligning screws on the single bar with mounting holes and lock it securely with the ball nut. Put the candle sleeve over the lamp holder.

5. Install the light bulbs(not included) by the fixture’s specifications.
   NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!

6. With silicone caulking compound, caulk completely around where the back of the cover meets with the wall surface to prevent water from seeping into outlet box.

**CONNECTING THE WIRES

**

1. Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has ground wires (green or bare copper) connect the fixture’s ground wire to it. Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
2. Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction box and test the fixture.

Thank you for purchasing an AVIANCE product.
Need assistance with parts or assembly? Please email customer service at:info@aviancelighting.net

©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING,INC.
DOC202404HD56497

Frequently Asked Questions

• Q: Can this product be used outdoors?
  • A: No, this product is designed for indoor use only.
• Q: What is the warranty period for this product?
  • A: The warranty period for this product is [Warranty Period].
    Please refer to the warranty information included in the packaging.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>