super bright leds HBUD-MS LED High Bay Light User Manual

super bright leds HBUD-MS LED High Bay Light

Specifications

• Product: LED High Bay Light HBUD2 Series
• Operating Temperature: Check product label
• IP Rating: IP65

Product Usage Instructions

1. Eye Bolt/Hook Installation Instructions

1. Thread eye bolt/hook into the hole on top of the fixture and tighten.
2. Hang the fixture securely.
3. With the supply power switched off, connect the wiring.

2. U-Bracket Installation Instructions

1. Secure mounting plates to the fixture with provided screws.
2. Attach the U-bracket to the mounting plate with provided screws and nuts.
3. Attach the mounting bracket to the desired surface.
4. Position the U-bracket at the desired angle and secure it in place.
5. With the supply power off, connect the wiring.

3. Polycarbonate Reflector Installation Instructions

1. Turn the fixture upside down if needed.
2. Line up the three holes on the reflector with the three threaded holes on the light.
3. Attach the reflector using the provided screws.

4. HBUD-MS Motion Sensor Installation Instructions

1. Remove supply power prior to installation.
2. Position the motion sensor and sensor junction box on opposite sides of the light and attach using the provided hardware.
3. Connect wiring according to the wiring diagram provided.

Frequently Asked Questions

• Q: What should I do if I encounter issues during installation?
  • A: If you encounter any issues during installation, please refer back to the user manual for troubleshooting steps or contact customer support for assistance.
• Q: Can I use additional accessories with this LED High Bay Light?
  • A: Yes, you can use optional accessories like motion sensors or dimming features. Refer to the installation instructions for these accessories included in the user manual.

Specifications

Check product label for specific electrical specifications related to installation. Improper installation will void warranty

Optional Accessories]

• 100–300 W versions
• HBUD-MS (microwave motion sensor)
• HBUD-8 (polycarbonate reflector)
• HBUD-8-UB (U-bracket)

Safety and Notes

• Product should be installed and serviced by a certified electrician in accordance with applicable national, state, and local building and electrical codes.
• To reduce the risk of electric shock, ensure that the main power source and circuit \breakers are switched off before performing any installation or wiring procedures. • Avoid looking directly into lamp when illuminated.
• Ensure all mounts are securely attached and will support the weight of the fixture. Failure to properly support fixture may result in damage or injury, for which the\ manufacturer does not assume responsibility.

Wiring Diagram

100–277 VAC / 277–480 VAC Input

Installation Instructions

Eye Bolt/Hook Installation Instructions

1. Thread eye bolt / hook into hole on top of fixture and tighten.
2. Hang fixture securely.
3. With supply power switched off, connect wiring.

U-Bracket Installation Instructions

1. Secure mounting plates to fixture with provided screws.
2. Attach U-bracket to mounting plate with provided screws and nuts.
3. Attach the mounting bracket to desired surface.
4. Position U-bracket at desired angle and secure in place.
5. With supply power off, connect wiring.

Important: Read all instructions prior to installation.

Polycarbonate Reflector Installation Instructions

1. Turn fixture upside down, if needed.
2. Line up the three holes on reflector with three threaded holes on the light.
3. Attach reflector using provided screws

HBUD-MS Motion Sensor Installation Instructions

1. Remove supply power prior to installation.
2. Position motion sensor and sensor junction box on opposite sides of the light and attach using provided hardware.
3. Connect wiring according to wiring diagram below.

Contact

• 4400 Earth City Expy, St. Louis, MO 63045
• 866-590-3533
• superbrightleds.com

References

• LED Lighting For Everything | Super Bright LEDs

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>