AURA DRL HALO RGB Ford Mustang 05-14 Installation Guide

AURA DRL HALO RGB Ford Mustang 05-14

COMPONENTS

• LIGHT STRIPS
  

• MOUNTING KIT

• AURA CONTROL BOX
  

• HAND HELD REMOTE
  

• FUSE TAPS

• EXTENSION WIRES
  

• CIGARETTE LIGHTER POWER ADAPTER
  

• POWER HARNESS
  

INSTALLATION

• STEP 1
  
  Open the hood.
  

• STEP 2
  
  Wrap the LED strip into a circle shape and firmly press into place inside of the intake hole to secure.
  AND/OR
  
  Attach the strip as pictured as an alternate method of install.

• STEP 3
  
  Remove the plastic covers on the right and left side of the engine bay

• STEP 4
  
  Run the wires along the front brace and connect to the control box.

• STEP 5
  
  Connect the positive wire to a constant (always on) or accessory (only when the car is on) circuit in the fuse box by using an included fuse tap.

• STEP 6
  
  Connect the negative wire to a ground source, such as the one circled in the picture.

• STEP 7
  
  Test for function.

• As shown below, connect all light pods to the control box with the included extension cables.
  
  

• OPTIONAL: 2 x 12” Strips can be used to enhance your front grille or use as spares.
  
  ***** IMPORTANT: The LED connectors are not waterproof. You will need to use HEAT SHRINK TUBE (not included) or ELECTRICAL TAPE around the LED connectors to ensure the longevity of the lighting kit.

• Once connected, plug the control box Cigarette Power Adapter into an available 12 volt charging port.
  

• or connect the positive wire to the fuse tap and connector the open negative wire to a ground (any metal surface). Then plug the fuse tap into the 10amp switched fuse.
  

WARNING: Please ensure that the led strips/control box/wiring all are mounted in areas of the engine bay that will not exceed 85C or 185F

AUX WIRING FOR A DOOR/DOME LIGHT

Please scan to see a detail instruction on Door Assist Sync or go to
https://wintis.ladesk.com/549690-AURA-Door-AssistAUX-Installation-Guide

DISCLAIMER

OPT7 Lighting is not liable for damages or personal injuries while installing this product. The Installation Guide is intended as assistance to reduce setup time. OPT7 Lighting assumes no responsibility for improper installation. If you are unfamiliar with your vehicle or inexperienced with aftermarket upgrades, please seek professional assistance.

References

• OPT7 - LED Lighting for Cars, Trucks & Motorcycles – OPT7 Lighting Inc

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>