LEXON LR155 Ray Clock Alarm Clock Gold User Guide

: June 28, 2024
: LEXON

Table of Contents

LEXON LR155 Ray Clock Alarm Clock Gold
Product Introduction
CHARGING
PRODUCT SPECIFICATIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LEXON LR155 Ray Clock Alarm Clock Gold

Product Introduction

IN THE BOX

1x Ray Clock
1x USB-C charging cable
1x User manual

OVERVIEW

Display (A)

Time
Time setting mode
Alarm setting mode
Brightness setting mode / night mode
Temperature in °C/°F
Date
Relative humidity
AM/PM (12-hour format)
Alarm ON
Charging & battery status

Device (B)

a. Touch surface
b. Ventilation holes
c. USB-C port
d. + key
e. Alarm setting key
f. Brightness setting key
g. Power ON/OFF key
h. Time setting key
i. – key

CHARGING

Charging via USB-C cable

Plug the provided USB Type-C cable into the charging port of Ray Clock.
Plug the USB end of the cable into any computer or any DC 5V power charger.
A charging icon will display on the LCD screen when charging.
A fully charge takes approximately 4 hours.
Note : When the battery is low (device unplugged from a power source), the battery icon will keep flashing until the device completely runs out of power.

OPERATIONS

Important note: Ray Clock has a built-in battery that allows it to operate without being constantly plugged in. When not plugged in, the LED display automatically switches ON when you touch the top surface. The LED backlight remains ON for 5 seconds and then dims for 15 seconds before entering standby mode. Ray Clock can be permanently plugged in with a 5V USB power adaptor. When plugged in, the LED display stays ON permanently.

Activate the alarm (A): Tilt the alarm clock upwards

Stop the alarm (B): Tilt the alarm clock downwards or press any button at the back.
Check alarm time: Press the “Alarm setting” key to see the alarm time at any time.
Snooze: When the alarm sounds, gently touch the top surface of Ray Clock once to activate snooze. The alarm will sound again after 6 minutes.
Turn the alarm off permanently: To disable the alarm completely (whatever its position) and use Ray Clock as a simple clock, press the button three times. Repeat the same operation to reactivate it.
Important note: Each time the alarm is activated (alarm clock tilted up again), the set alarm time appears on the display for 10 seconds before returning to the time display.

Other features/operations

Backlight: At night, tap on the top surface to light up the screen.
Night mode: Only works when the alarm clock is plugged in. To enable or disable the night mode, press key once. When the night mode is enabled, the brightness icon remains on screen. The alarm clock enters night mode from 10:00 pm to 8:00 am, facilitating a more comfortable sleeping environment.
Brightness adjustment: Press and hold the key. Press or/and keys to adjust the brightness level then press key to confirm.
Temperature unit: Press or/and keys to change the temperature unit.
Display mode: By default, temperature and humidity data are displayed on the screen. Press key to hide or unhide indoor temperature and hygrometry data.
Reset: Press and hold and key until you hear a bip to reset the device.

SAFETY INFORMATION

Retain Instructions: The safety and operating instructions should be retained for future reference.
Power Sources: The device should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance.
Ventilation holes: Do not obstruct the 2 holes on the back of the product.
Water and Moisture: The device should not be used near water.
Heat: The device should be placed away from heat sources such as radiators, heat registers, stoves, or other appliances that produce heat.

PRODUCT SPECIFICATIONS

Dimensions: 3.54 x 1.73 x 2.9″ / 9 x 4.4 x 7.4 cm
Weight: 0.51″ / 230 g
Material: Aluminum / ABS / Silicone
Battery capacity: 2000 mAh
Battery voltage: 3.6V
Battery life: Up to 6 months
Charging time: 4h
Charging system: USB Type-C
Input: 5V
Frequency band: 32.786 kHz
International warranty: 1 year

EUROPEAN UNION
CE DIRECTIVE
LEXON hereby declares that this device is in compliance with the essential requirements and other relevant provisions of the directives 2014/30/EU & 2011/65/EU. The original EU declaration of conformity may be found at: https://www.lexon-design.com/assets/certifications-ce-rayclock.pdf

UK CONFORMITY ASSESSMENT
The object of the declaration described above is in conformity with the relevant Union harmonization legislation.
The original UK declaration of conformity may be found at: https://www .lexon-design.com/assets/certifications-ukca-rayclock.pdf

DISPOSAL AND RECYCLING INFORMATION

After the implementation of the European Directive 2012/19/EU in the national legal system, the following applies: electrical and electronic devices may not be dis-posed of with domestic waste. Consumers are obliged by law to return electrical and electronic device at the end of their service lives to the public collecting points set up for this purpose or point of sale. Details to this are defined by the national law of the respective country. This symbol on the product, the instruction manual or the package indicates that a product is subject to these regulations. By recycling, reusing the materials or other forms of utilizing old devices, you are making an important contribution to protecting our environment.

125, Avenue des Champs-Elysees – 75008 Paris – FRANCE
All trademarks, logos and brand names are the property of their respective owners.
Pictures and specifications are not contractual. Assembled in China.
lexon-design.com
@lexondesign