HiLetters HiNeon Custom Neon Sign User Manual
- June 3, 2024
- HiNeon
Table of Contents
HiNeon Custom Neon Sign
User Manual
HiLetters HiNeon Custom Neon Sign
SAFETY INSTRUCTIONS
Please carefully study the instruction manual and information below before installing or using this product. Please keep this user manual for further reference.
-
This LED neon sign is intended for indoor application only. Do not use in damp or wet locations.
Do not install it in an area that will exceed 120°F (49°C). -
This LED neon sign works only with low voltage 12V DC. Please always use the attached power adapter to power up the sign. Do not connect the sign directly to the line voltage. If in any doubt, please consult a local electrician.
-
Disconnect power before handling or cleaning. Maintenance of the luminaires is limited to their surfaces. During maintenance, no moisture can come into contact with any areas of the terminal connections or voltage control parts.
-
Clean with a soft, dry cloth. Do not use solvents or chemicals. Avoid dampness on all electrical components.
| **** | For indoor use only. Avoid direct contact with water. |
|---|
DC
12V| The light is designed to work only with the indicated voltage.
Different items require different working voltages.
| This electric sign is built in compliance with UL requirements and
standards.
| This luminaire cannot be disposed of with regular domestic waste in a
standard rubbish can. You have to bring it to a staging area for electrical
waste.
INSTALLATION
|
---|---
Prepare your HiLetters Neon Set (HiLetters, magnetic support rail, cord
connector, and 12V power adaptor)| Arrange your magnetic LED letters to your
desired message onto the rail facing front. The front side is marked with a
sticker.
|
Plug in the neon wire and connect the cord connector to the 12V power
adaptor.| Get your wall installation accessories (screws, nail anchors, and
wall mounts).
|
Pencil mark the screw hole locations and drill onto the marked locations.|
Take the drywall anchors and tap them into the holes using a hammer.
|
Now align the holes of your wall mounts and the nails into the drywall
anchors.| Unscrew the left cap of the rails and slide the wall mount in. Then
screw the cap back in place.
|
Now you can arrange your HiLetters on the rail facing front. You can remove
the sticker once done.| Connect the wires to the rail and you’re ready to
light up your neon sign.
NEED MORE ASSISTANCE?
Call: +1 833 768 7999
Email : hello@hineon.com
Visit: www.hineon.com/faq/
SCAN
TO VISIT FAQ PAGE
https://hineon.com/ufaq/installing-hiletters-neon-sign/
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>