bouncepad FS-BRD-B4-PL7-MG Secure Tablet and iPad Kiosk Instruction Manual

bouncepad FS-BRD-B4-PL7-MG Secure Tablet and iPad Kiosk Instruction Manual

Assembly Instructions

Tools Required:

• Socket Driver
• 10mm Spanner *or adjustable spanner

Sheet Code: BP-IM-047_REV4
Release Date : 10/04/2024
Copyright 2024 Spot spot Ltd. (T/A Bounce pad) all rights reserved.
Confidential, no part of this publication may be reproduced or transmitted in any form without the written permission of the copyright holder.

In the Box

Fixings List

• Due to the modular nature of our product range you may receive additional fixings in the fixings kit

  1. Orientate, locate and secure the Floor standing Pole to the Floor standing Base as shown. Ensure that all fixings are installed correctly.

  2. Locate the Floor standing Cover over the Floor standing Pole.

  3. Locate and secure the Case onto the Mounting Arm as shown. Tighten by hand.

  4. Unlock & remove the Face plate from the Bounce pad Case.

  5. Feed the tablet power cable through the Case & Floor standing Pole.

  6. Install the Tablet Setup Kit. Each kit is specific per device & case.

  7. Install the tablet into the Case & connect to power.

  8. Locate and lock the Face plate to the Case.

  9. Connect the tablet power cable to its mains power source.

  10. If installing a battery pack, connect the tablet cable and locate the pack into the Floor standing Base.

designed to support the Ranker Power Core 10000mAh.
battery pack is not provided. 10. With the Floor standing Cover on the ground, locate and fit the Floor standing Rubber Collar.

11. Use a Pennington® Micro saver product to tether to a secure object. (refer to your Pennington® instructions for full details)

12. Installation is now complete.

Follow these instructions for the successful assembly of your Branding board to your Floor standing.

Sheet Code: BP-OR-IM-011_REV2
Release Date : 01/04/2019
Copyright 2016 Spotspot Ltd. (T/A Bounce pad) all rights reserved.
Confidential, no part of this publication may be reproduced or transmitted in any form without the written permission of the copyright holder.

Tools required

Branding Mount – In the Box

1. Follow ‘A’ steps if installing a Placard board

2. Locate the top Bracket Mount & A2 Mount Bolt to Floor standing pole.

3. Ensure that the Bracket Mount & Mount Bolt are positioned correctly as shown.

4. Secure the Bracket Mount & Mount Bolt to the Floor standing Pole with the supplied Nuts. Tighten evenly

5. Locate the Placard Board to the Bracket Mount. Secure with the supplied Plastic Screws & Nuts.

6. Locate & secure the bottom Bracket Mount & Mount Bolt. Tighten the nuts evenly

7. Secure the bottom section of the Placard Board with the Plastic Screws & Nuts. Installation now complete.

8. Follow ‘B’ if installing a Front Board

9. Locate the top Bracket Mount & Mount Bolt to the Floor standing pole.

10. Ensure the Bracket Mount & Mount Bolt are positioned correctly as shown.

11. Secure the Bracket Mount & Mount Bolt to the Floor standing Pole with the supplied Nuts. Tighten evenly

12. Locate the Front Board to the Bracket Mount. Secure with the supplied Plastic Screws & Nuts.

13. Locate & secure the bottom Bracket Mount & Mount Bolt. Tighten the nuts evenly

14. Secure the bottom section of the Front Board with the Plastic Screws & Nuts. Installation now complete.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>