COSHARE HD10E Hair Care Fast Drying Hair Dryer User Manual

COSHARE HD10E Hair Care Fast Drying Hair Dryer User Manual

Product Instruction

1. Air outlet: the air outlet is equipped with a magnetic iron ring that can be magnetically fixed to the air nozzle.

2. Sliding switch: slide up to turn it on; slide down to turn it off .

3. Air temperature button: there are 4 settings to switch among by gently pressing:
   Cool air (blue)
   Warm air (orange)
   Hot air (red)
   Circulating mode (red and blue flashing alternately)

4. Air speed button: a total of 3 modes for you to switch among by gently pressing:
   Low speed mode (blue)
   Medium speed mode(orange)
   High speed mode (red)

5. Detachable protective cover/inlet air filter: the plastic protective cover may be rotated off, revealing the interior stainless steel air intake filter.

Function

Mode switch for air temperature

• Tap the air temperature button to switch the temperature in the following sequence: “cool air, warm air, hot air, cool air…”
• Press the air temperature button for 2 seconds to enter the automatic air circulation mode. At this mode, gently press the air temperature button to return to the cool air mode.

temperature.
Orange light is always on| warm air mode| The air temperature is kept constant at 57°C at 10cm from the air outlet, which does not harm the hair.
Red light is always on| hot air mode| The air temperature is kept constant at 75°C at 10cm from the air outlet, which is fast drying hair.
Red and blue alternately flashing| circulating mode| Automatic circulation of cold and hot air every 5 seconds.

Mode switch for air speed
Tap the air speed button to switch the speed modes in the following sequence: “low speed, medium speed, high speed, low speed…

styling
Orange light is always on| medium speed mode| suitable for scenes with sufficient time
Red light is always on| high-speed mode| suitable for quick drying scenes

One-key dust removal function
While the hair dryer is on and at low speed mode, press the air speed button for 5 seconds to activate the reverse dust removal function. The motor fan gradually stops and start reverse rotation. The dust removal is complete after 10 seconds of reverse rotation, and the motor fan will automatically stop to prevent damage to the equipment.

Note:

1. When the hair is moist after shampoo, the hot air mode is ideal. When the hair is going to dry, as the humidity is low, it is better to switch to the cool/warm air or circulating mode to avoid hair damage brought by the high temperature from the hot
   air.

2. At the hot air mode, the temperature at the air outlet will be more than 100°C, so please keep away from the air outlet when you use it.

3. According to scientific experiments, the critical temperature for hair scales to start damaging is 60°C. The warm air mode keeps a constant temperature at 57°C, which aims to care your hair to the fullest.

Product Specification

Product Name: Hair Dryer
Model Number: HD10E
Rated Voltage: 230V~
Rated Frequency: 50Hz
Rated Power: 1600W
Product Size: 249X85X69mm
Cable Length：2m

Features

Super high air speed

At a maximum air speed of 22m/s, the 110,000 rpm three-phase high-speed brushless motor provides strong airflow for efficient hair drying.

Intelligent constant temperature control

The built-in temperature sensor is installed at the air outlet.
To prevent from hair damage due to overheating, the sensor controls temperature nicely at the frequency of the temperature calibration of 100 times per second according to different temperature modes

Hair care with negative ions

With a concentration of 300 million negative ions, the built-in negative ion generator reduces static amount in hair to prevent frizz and flyaways caused by static electricity.

Hot and cold circulating air

Thanks to the automatic circulation of cold and hot air every 5 seconds, the hair dryer would not blow hot air on one area continuously, which prevents hair burn efficiently. Whether you are styling your hair or drying long hair, you can concentrate on one area without worry.

One-key dust removal function

The motor fan supports reversing and one-key dust removal. It automatically cleans dust particles accumulated in the air duct and filter after extended periods of use, ensuring that the product always performs well.

Instructions

1. Tear off the plastic bag and take out the shine ring and bracket.
2. Combine the shine ring and bracket together correspond-ingly.correspondingly.
3. Rotate to tighten the two into one.
4. Attach the shine ring and bracket to Coshare hair dryer with magnetic adsorption, and it can be used normally.

Cleaning and Maintenance

1. To remove the protective cover, turn it counterclockwise.
2. After removing the protective cover, set the hair dryer’s air speed to low, then press the air speed button for 5 seconds to activate the reverse dust removal function; the hair dryer will gradually stop and start reverse rotation for 10 seconds to remove the fine rubbish and dust from the air duct.
3. After cleaning, turn off the blower by depressing the sliding switch and return the protective cover to its original position.
4. After turning off and on again, the hair dryer will revert to regular operation and blow out air normally

Important

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

• When the hairdryer is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the hairdryer is switched off.

• For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30 mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.

• WARNING: Do not use this appliance near bathtubs, showers, basins or other vessels containing water.

• Keep away from water! Do not use this product near or over water contained in baths washbasins, sinks, etc. If, for some reason, the product has fallen into water: first unplug immediately. Then, dispose of the product. It must not be used again.

• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

• Even when the hair dryer is switched off, the power is still on.
  Always pull out the mains plug when not in use.

• Never obstruct the air grills.

• This product is equipped with an automatic overheating protection device. If the appliance overheats, it will switch off.
  Unplug the appliance. After cooling down for a few minutes, the appliance can be used again. Before reusing, check the inlet and outlet grilles for possible blockage by fluff, hair, etc. If in doubt, consult your dealer or a COSHARE Service Centre.

• If the mains cord of this appliance is damaged, it must only be replaced by COSHARE or their service representative, as special tools and/or parts are required.

• For examination or repairs always return the appliance to an authorized COSHARE service centre. Unqualified repair work can lead to extreme hazards for the user.

WEEE Disposal and Recycling Information

All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should not be mixed with unsorted household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated collection point for the recycling of waste electrical and electronic equipment, appointed by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. Please contact the installer or local authorities for more information about the location as well as terms and conditions of such collection points.

Environment friendly disposal
You can help protect the environment!
Please remember to respect the local regulations: hand in the non-working electrical equipments to an appropriate waste disposal centre. The packaging material is recyclable.
Dispose of the packaging in an environmentally friendly manner and make it available for the recyclable material collection-service.

WARNING: Do not use this appliance near bathtubs, showers, basins or other vessels containing water.

Hereby, Shenzhen Cuco Smart Technology Co.,Ltd declares that the hair dryer is compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: https://cedeclaration.gosund.com

FAQ

Q: What’s the function of ShineRing?

A: The ShineRing contains a hair conditioner enriched with nourishing ingredients like amino acid squalene, to help repair damaged hair cuticles, smooth roughness, and deeply nourish hair.

Q: The hair dryer doesn’t work, or the red/white indicator flash quickly.

A:

1. The hair dryer may be overheated, please keep it rest for about 10 minutes before using it again.
2. The voltage may be unstable, it is recommended to replace another wall socket to try again.
3. The filter is blocked, it is recommended to clean the filter

Customer Service email: services@coshareglobal.com
Official website: www.coshareglobal.com
Manufacturer: Shenzhen Cuco Smart Technology Co., Ltd.
Address:Room 201, 301, Building A, No.12 Difu Road, Guxing
Community, Xixiang Street, Bao’an District,
Shenzhen,518000,Guangdong, P. R. China

References

• cedeclaration.gosund.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>