STANLEY SXLS35525E 20W LED Worklight Instruction Manual
- June 6, 2024
- Stanley
Table of Contents
STANLEY SXLS35525E 20W LED Worklight Instruction Manual
SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE
The thick and thin horizontal line field and the engineering plan packaging design are trademarks of Stanley Tools.
CUSTOMER SUPPORT:
For customer service please visit the Online Customer Service Centre
at:www.2helpU.com
READ ALL INSTRUCTIONS
Safety
-
These instructions are for your safety. Please read through them thoroughly prior to installation and retain them for future reference.
-
Always organise cables and extension leads so that they will not be a trip hazard.
-
If the external flexible cable or cord of this luminaire is damaged, it must only be replaced by a qualified electrician to avoid any electrical hazards.
-
Check the pack and make sure you have all of the parts listed.
-
Remove all packaging, wrap etc. from the product.
-
Decide on the appropriate location for your product.
-
IP65 product: Totally protected against dust. Protected against low pressure jets of water from all directions. Limited ingress permitted.
-
Always refer to the installation drawing for the orientation of the product.
-
Never put anything on the product or hang anything on any part of this product.
-
When the product does not light after installation:
Ensure there is no electricity failure
Ensure all the connections are secured -
Always disconnect the product from mains at least 10 minutes allowing to cool down before any maintenance or adjustment.
-
CAUTION: Do not stare at the operating LED light source.
Cleaning care
- The lamp can be cleaned with a clean dry cloth. Do not immerse it in water.
- Always switch off the supply before cleaning.
Parts Supplied
Installation Instructions
Images for illustration purposes only – Product may differ slightly from the one shown
Technical Data
2-YEAR LIMITED WARRANTY
The warranty of this product is covered by Cascade Holdings Ltd.
© Stanley Black & Decker, Inc.
STANLEY and the STANLEY Logo are trademarks of Stanley Black & Decker, Inc or
one of its affiliates, and are used under license.
Products are manufactured by:
Cascade Holdings Ltd.
Gorse Mill, Gorse St
Oldham, OL9 9RJ U.K.
www.stanleytools.co.uk
Eu Authorised Representative:
Authorised Rep Compliance
Ground Floor
71 Lower Baggot Street
Dublin
Ireland
D02 P593
Documents / Resources
|
STANLEY SXLS35525E 20W LED
Worklight
[pdf] Instruction Manual
SXLS35525E, 20W LED Worklight
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>