bouncepad FBR-B4-SG2-MX Floor Standing with Brother Printer Mount Tablet Security Enclosure Instruction Manual
- June 1, 2024
- bouncepad
Table of Contents
bouncepad FBR-B4-SG2-MX Floor Standing with Brother Printer Mount Tablet
Security Enclosure Instruction Manual
Floorstanding with
Brother Printer Mount
Assembly Instructions
Tools Required
- Socket Driver
- 10mm Spanner *or adjustable spanner
Sheet Code: BP-IM-057_REV2
Release Date: 26/03/2024
Copyright 2016 Spotspot Ltd. (T/A Bouncepad) all rights reserved.
Confidential, no part of this publication may be reproduced or transmitted in
any form without the written permission of the copyright holder.
In the Box (Floorstanding)
Fixings List (Floorstanding)
* Due to the modular nature of our product range you may receive additional fixings in the fixings kit
In the Box (Printer Mount)
Fixings List (Printer Mount)
1 Orientate, locate and secure the Floorstanding Pole to the Floorstanding Base as shown. Ensure that all fixings are installed correctly.
2 Locate the Floorstanding Cover over the Floorstanding Pole.
3 Remove Neck-Ring using T20 driver bit and Socket Driver
4 Feed the printer’s power cable through the Floorstanding Pole
5 Attach the printer to the Printer Mount using M3x10mm Screws
6 Feed power cable through Printer Mount and plug into Printer
7 Re-attach Neck-Ring
8 Pull cable back to remove any slack near the Printer Mount
9 Locate and secure the Case onto the Mounting Arm as shown. Tighten by hand.
10 Unlock & remove the Faceplate from the Bouncepad Case.
11 Feed the tablet power cable through the Case & Floorstanding Pole.
12 Install the Tablet Setup Kit. Each kit is specific per device & case.
13 Install the tablet into the Case & connect to power.
14 Locate and lock the Faceplate to the Case.
15.1 Connect the tablet power cable to its mains power source.
15.2 If installing a battery pack, connect the tablet cable and locate the pack into the Floorstanding Base.
16 With the Floorstanding Cover on the ground, locate and fit the Floorstanding Rubber Collar.
17 Use a Kensington® Microsaver product to tether to a secure object. (refer to your Kensington® instructions for full details)
18 Installation is now complete.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>