EVOLUTION POWERSPORTS 203FC0051 X3 The Clamp Plenum Brace Instruction Manual
- June 3, 2024
- EVOLUTION POWERSPORTS
Table of Contents
EVOLUTION POWERSPORTS 203FC0051 X3 The Clamp Plenum Brace
INCLUDED PARTS
- EVP “The Clamp”
REQUIRED TOOLS
REQUIRED TOOLS
INSTALLTION STEPS
- Step 1: Remove rear valence
- Step 2: Remove muffler
- Step 3: Unplug MAP sensor and remove from plenum
- Step 4: Cover MAP sensor hole with tape
- Step 5: Using a Dremel tool or air grinder, remove tabs shown in the picture below. Be careful not to compromise the integrity of the runners by only removing as much material as necessary for THE CLAMP installation.
- Step 6: Once tabs are removed put the left half of the inside in place first and then the right.
- Step 7: Now that all (3) pieces are installed, start all (4) bolts before tightening them down. Put Loctite on the threads of the bolts.
- Step 8: When tightening the (2) bottom bolts it is easiest to use a 6mm Allen socket.
- Step 9: Tighten all (4) bolts.
Thank you for choosing Evolution Powersports products. If you require further
assistance, please call our Tech Support @
715-247-3862
Note: This product is exempt from the emission standards and related
requirements of 40 C.F.R. § 1051 as provided by 40 C.F.R. § 1051.620, and
California law [e.g., vehicle code§§ 27156 and 38391]. This product is sold
only for use in connection with EPA certified, purpose-built, nonroad vehicles
used solely for closed course, nonroad competition/racing and not used for any
recreational purpose or on public highways or right of ways maintained by and
open to the public. This product is sold only in connection with machines that
do not fall under state and/or federal noise or emission
standards/regulations. Purchasers who/that purchase this product represent and
warrant that the product is purchased only in connection with EPA -certified,
emission-regulations-exempt and noise-regulations-exempt competition/racing
vehicles as interpreted under applicable state and/or federal law. Questions:
Call Evolution Powersports at
715-247-3862.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>