Beldray Airgility Cordless Stick Vacuum Lightweight Instruction Manual
- June 6, 2024
- Beldray
Table of Contents
- Safety Instructions
- Battery Safety
- Dos and Don’ts
- Care and Maintenance
- Getting Started
- In the Box
- Features
- Description of Parts
- **Instructions for Use
- Emptying the Dust Container
- Cleaning the HEPA filter
- Cleaning the Floor Brush
- Removing the Rechargeable Battery Pack
- Storage
- Troubleshooting
- Specifications
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Beldray Airgility Cordless Stick Vacuum Lightweight Instruction Manual
Please read all of the instructions carefully and retain for future reference.
Safety Instructions
When using electrical appliances, basic safety precautions should always be
followed.
Check that the voltage indicated on the rating plate corresponds with that of
the local network before connecting the appliance to the mains power supply.
Children aged from 8 years and people with reduced physical, sensory or mental
capabilities or lack of experience and knowledge can use this appliance, only
if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
Children should be supervised to ensure that they do not play with the
appliance.
Unless they are older than 8 and supervised, children should not perform
cleaning or user maintenance.
This appliance is not a toy.
This appliance contains no user serviceable parts. If the power supply cord,
plug or any part of the appliance is malfunctioning or if it has been dropped
or damaged, only a qualified electrician should carry out repairs. Improper
repairs may place the user at risk of harm.
Keep the appliance out of the reach of children.
Keep the appliance out of the reach of children when it is switched on or
cooling down.
Keep the appliance away from heat or sharp edges that could cause damage.
Keep the appliance away from other heat emitting appliances. Keep the
appliance free from dust, lint, hair or anything that may reduce the airflow
of the appliance.
Do not immerse the appliance in water or any other liquid.
Do not operate the appliance with wet hands.
Do not expose the appliance to rain.
Do not remove the adaptor from the mains power supply by pulling the cord;
switch off and remove the plug by hand.
Do not use the adaptor to recharge non-rechargeable batteries.
Do not use the appliance if it has been dropped or if there are visible signs
of damage.
Do not use the appliance for anything other than its intended use.
Do not use any parts/accessories or adaptors other than those supplied with
this appliance, as this may cause damage.
Do not use any damaged accessories or adaptors.
Do not use this appliance outdoors.
Do not store the appliance in direct sunlight or in high humidity conditions.
Do not use this appliance if any of the openings are blocked.
Do not use the appliance to pick up flammable liquid, matches, cigarette ends,
hot ashes or any hot, burning or smoking objects.
Do not use this appliance to pick up hard, sharp objects such as glass or
nails etc.
Do not use the appliance to pick up water or any other liquid, as this poses
risk of an electric shock.
The hose should be checked regularly and must not be used if damaged.
Take care when equipping accessories with rotating parts as this could cause
entrapment.
Switch off the appliance and disconnect it from the mains power supply before
changing or fitting accessories.
Always ensure that the appliance has cooled fully after use before performing
any cleaning or user maintenance.
Use of an extension cord with the appliance is not recommended.
Only use the appliance with the power supply unit provided.
This appliance should not be operated by means of an external timer or
separate remote control system.
This appliance is intended for domestic use only. It should not be used for
commercial purposes.
Caution: The extension tube contains electrical connections.
Do not use to suck up water. Do not immerse in water for cleaning. The
extension tube should be checked regularly and must not be used if damaged.
Battery Safety
If the battery pack becomes exhausted, it should be removed from the product
to avoid leakage.
In the event of the battery pack leaking, do not allow any liquid to come into
contact with the skin or eyes.
If contact has been made, wash the affected area with copious amounts of water
and seek medical advice.
Keep the battery pack out of the reach of children.
Secondary battery packs need to be charged before use.
After extended periods of storage, it may be necessary to charge and discharge
the batteries several times to obtain maximum performance.
Do not leave battery packs on charge for prolonged periods of time.
Do not use any charger other than that specifically provided for use with the
product.
The supply terminals are not to be short-circuited.
Do not store above 60 °C. Avoid storing in direct sunlight.
Do not use any battery packs that are not designed for use with the product.
Do not dispose of the battery pack in a fire.
Do not crush, puncture, dismantle or otherwise damage the battery pack.
Do not dismantle, open or shred battery packs.
Do not expose the battery pack to heat or fire as it may explode.
Do not subject the battery pack to mechanical shock.
Do not dispose of the exhausted battery pack in household waste.
To dispose of the exhausted battery pack, take it to a local recycling
station. Contact the local government offices for further details.
This appliance is fitted with a 22.2 V 2200 mash Li-ion rechargeable battery.
Dos and Don’ts
Do:
Check that the HEPA filter is kept clear of obstruction.
Make sure that the dust container and HEPA filter are cleaned regularly to
preserve suction and prolong the life of the vacuum cleaner. Clean the dust
container and HEPA filter at least every three weeks with clean water to keep
the vacuum cleaner working efficiently.
Don’t:
Use the vacuum cleaner without the HEPA filter or dust container in position.
Use the vacuum cleaner to pick up flammable liquid, matches, cigarette ends,
hot ashes or any hot, burning or smoking objects. Use the vacuum cleaner to
pick up water or any other liquid, as this poses risk of an electric shock.
Care and Maintenance
Wipe the external surface of the vacuum cleaner with a soft, damp cloth and
allow to dry thoroughly.
Do not use any harsh or abrasive detergents or cleaning agents to clean any
part of the vacuum cleaner.
Keep the HEPA filter clean and replace when it becomes worn.
Getting Started
Remove the vacuum cleaner from the box.
Remove any packaging from the vacuum cleaner.
Place the packaging inside the box and either store or dispose of safely.
In the Box
Airgility Cordless
Extension tube
Floor brush
2 in 1 crevice and brush tool
Mains power adaptor
Battery
Instruction manual
Features
22.2 V removable Li-ion battery
5 hours charge time
25-40 minutes operating time
2 speed settings
1.2 L dust container
Motorized floor brush with LED lights
Includes 2 in 1 crevice and brush tool
Washable HEPA filter
Description of Parts
- Airgility Cordless main unit
- Air inlet
- Extension tube
- Extension tube release button
- Floor brush
- Floor brush release button
- Brush bar
- Brush bar release tab
- 2 in 1 crevice and brush tool
- Power trigger
- Dust container
- Dust container base release latch
- Filter cone
- HEPA filter
- Battery pack
- Battery release catch
- Charging port
- LED indicator light
- Storage hook
**Instructions for Use
**
**Before First Use
**
Before using the vacuum cleaner for the first time, clean the exterior surface
with a soft, damp cloth and dry thoroughly.
Do not immerse the vacuum cleaner in water or any other liquid.
Charging the Airgility Cordless
Before first use, the vacuum cleaner must be charged for approx. 5 hours.
Subsequent charging times will vary dependent upon use. If the vacuum cleaner
battery becomes drained completely during use, it may take up to 5 hours to
fully recharge.
The battery pack must be fitted onto the vacuum cleaner main unit during
charging; do not charge the battery pack separately.
STEP 1: Before connecting to the mains power supply, attach the battery
pack by aligning it with the main unit and sliding into place until it clicks.
STEP 2: Connect the mains power adaptor to the charging port on the
battery pack.
STEP 3: Plug the mains power adaptor into the mains power supply; the LED
indicator light will flash during charging and then remain illuminated once
the battery is fully charged.
STEP 4: Unplug the mains power adaptor from the mains power supply once
the battery is fully charged. Disconnect the mains power adaptor from the
charging port on the battery pack.
Note: Whilst charging, the battery pack may become warm.
Warning: Do not use any mains power adaptor other than that supplied.
Using an alternative will increase the risk of damage to the appliance or
injury to the user.
Using the Airgility Cordless
STEP 1: Check that the vacuum cleaner is disconnected from the mains
power adaptor after unplugging it from the mains power supply.
STEP 2: Turn on the vacuum cleaner by pressing the power trigger; press
once for the minimum power setting, press twice to use the maximum power
setting.
STEP 3: To turn off the vacuum cleaner, press the power trigger.
Warning: Do not use the vacuum cleaner without the HEPA filter and filter cone in position. The dust container must be closed before use. Clean the HEPA filter regularly to preserve the suction of the vacuum cleaner.
Using the Extension Tube and Floor Brush
The extension tube can be fitted onto the air inlet to extend reach, ideal for floor-to-ceiling cleaning.
STEP 1: Fit the extension tube onto the air inlet by aligning the pins
and carefully pushing the extension tube towards the main unit until it clicks
into position. To release the extension tube, press the extension tube release
button and pull it away from the vacuum cleaner main unit.
STEP 2: Attach the floor brush by aligning the pins on the floor brush
with the bottom of the extension tube. Carefully push together to secure into
place. To release the floor brush, press the floor brush release button and
pull it away from the extension tube.
STEP 3: Turn on the vacuum cleaner by pressing the power trigger.
Using the 2 in 1 Crevice and Brush Tool
STEP 1: If required, fit the extension tube onto the air inlet following
the instructions in the section entitled ‘Using the Extension Tube and Floor
Brush’.
STEP 2: Push the 2 in 1 crevice and brush tool onto the end of the
extension tube. If no extension is required, push the crevice tool directly
onto the air inlet until secure.
STEP 3: Slide the brush bar back to use as a crevice tool, ideal for
removing dust and dirt from corners and recesses. Slide the brush bar forward
to use as a brush tool, perfect for cleaning upholstery and fabrics.
STEP 4: To remove the 2 in 1 crevice and brush tool, pull it firmly away
from the end of the extension tube or the air inlet.
Emptying the Dust Container
Before emptying the dust container, check that the vacuum cleaner is switched off and any attachments have been removed from the air inlet. It is recommended to empty the dust container outdoors.
STEP 1: Whilst securely holding the vacuum cleaner main unit, press the
dust container base release latch. Empty the dust container slowly and
carefully to reduce the amount of dust released back into the atmosphere.
STEP 2: Close the dust container by pushing the base closed until the
dust container base release latch locks back into position.
Note: Always close the dust container base before using the vacuum cleaner.
Cleaning the HEPA filter
The HEPA filter can only be accessed when the dust container is open.
STEP 1: Open and empty the dust container following the instructions in
the section entitled ‘Emptying the Dust Container’.
STEP 2: Once the dust container is empty, remove the filter cone by
rotating it in an anticlockwise direction and lifting it out of the vacuum
cleaner main unit.
STEP 3: Carefully lift the HEPA filter out of the dust container. Shake
the HEPA filter until the majority of the dust has been removed, then rinse
under clean, warm water and allow to dry naturally.
STEP 4: Once the HEPA filter is fully dry, place it back into the dust
container. Replace the filter cone by aligning the indents on the filter cone
with those on the top of the HEPA filter. Secure into place by rotating the
filter cone in a clockwise direction.
STEP 5: Close the dust container by pushing it firmly shut until it
clicks into position.
Note: Do not clean the HEPA filter using detergents or use external heat
sources such as radiators to dry them.
Warning: Do not reassemble or use the vacuum cleaner until the HEPA
filter is fully dry, as this could cause damage.
Cleaning the Floor Brush
The floor brush has a removable brush bar for easy cleaning.
STEP 1: Switch off the vacuum cleaner and remove the floor brush by
pressing the floor brush release button and pulling it away from the extension
tube.
STEP 2: Slide the brush bar release tab to release the brush bar and lift
it out of the floor brush.
STEP 3: Remove any built-up dust, debris and hair from the brush bar and
floor brush.
STEP 4: Replace the brush bar into the floor brush by aligning the tabs
and sliding the brush bar release tab to the side, allowing the brush bar to
fit into place.
Removing the Rechargeable Battery Pack
The battery pack can be removed from the vacuum cleaner main unit by pressing the battery release catch and sliding the battery pack out of the main unit. To refit the battery pack, re-align it with the main unit and press the release catch down whilst sliding the battery pack into place until it clicks.
Storage
Check that the vacuum cleaner is cool, clean and dry before storing in a cool, dry place. The vacuum cleaner can be neatly stored away after use by securing the main unit onto the extension tube using the storage hook.
Troubleshooting
Specifications
Product code: BEL0776NTKFOB
Battery: 22.2 V DC 2200 mAh Li-ion
Adaptor Input: 100-240 V – 50/60 Hz
Adaptor Output: 26 V = 0.4 A 10.4 W
Average active efficiency: 83.81 %
Efficiency at low load (10 %): 75.78 %
No-load power consumption: 0.01 W
Dust tank capacity: 1.2 L
UP Global Sourcing UK Ltd.,
UK. Manchester OL9 ODD.
Germany. 51149 Koln.
If this product does not reach you in an acceptable condition please contact
our
Customer Services Department at www.beldray.com
Please have your delivery note to hand as details from it will be required.
If you wish to return this product please return it to the retailer from where
it was purchased with your receipt (subject to their terms and conditions).
The crossed out wheelie bin symbol on this item indicates that this appliance needs to be disposed of in an environmentally friendly way when it becomes of no further use or has worn out. Contact your local authority for details of where to take the item for recycling.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>