super bright leds LDRF-RGBW6-MZ MiBoxer Remote Pairing User Manual
- June 6, 2024
- super bright leds
Table of Contents
User Manual
MiBoxer Remote Pairing
Important: Read all instructions prior to installation.
Pairing Procedure for all MiBoxer Remotes
-
Make sure all connections are secure. Power supply and LEDs should all be hooked up and powered on.
-
Completely disconnect power through any of these methods:
-Unplug connector going to the MiBoxer controller.
-If using a power cord, unplug power supply from the wall.
-If hardwired to a switch, simply turn off the switch. -
With supply power off, touch any button on the remote and verify that the DOT in the middle of the color wheel lights up.
-
Start pressing the (I) button repeatedly. Zones are shown in example graphic to the right. Each zone contains it’s own (I) button and a (O) button.
-
Continue pressing (I) button as you restore power to the controller. Do not stop pressing (I) button until you see the LEDs starting to flash. Stop pressing (I)
button repeatedly. -
Once LEDs stop flashing, zone control has been successfully connected.
Rev Date: V1.0 06/21/2021
4400 Earth City Expy, St. Louis, MO 63045
866-590-3533
superbrightleds.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>