SUPER BRIGHT LEDS CDLxD Series Dimmable Commercial Downlight with Integrated Driver User Manual
- June 6, 2024
- super bright leds
Table of Contents
SUPER BRIGHT LEDS CDLxD Series Dimmable Commercial Downlight with
Integrated Driver User Manual
Important: Read all instructions prior to installation.
Safety and Notes
- This product should be installed by a certified electrician in accordance with applicable national, state, and local building and electrical codes.
- To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures.
- If installing as retrofit, carefully inspect any reused electrical components prior to installation.
- Avoid looking directly into the lamp when illuminated.
- Ensure the mounting surface will support the weight of the fixture.
Failure to properly support the fixture may result in damage or injury, for which the manufacturer does not assume responsibility.
Installation Instructions
Note: If replacing an existing luminaire, remove the old unit and disconnect from junction box.
- Measure existing cutout, if applicable. Trim existing hole or mark and cut appropriate size hole (Dim. A).
Model
| Dim A
---|---
CDL6D-xKx 6”
| (152mm)
CDL8D-xKx 8”|
(203mm)
-
Attach latch of seismic safety cable to secure location above mounting surface. (Fig. 1)
-
Attach luminaire’s conduit to junction box, make electrical connections, then close and secure junction box. (Fig. 1)
Note: A TRIAC can be installed to control dimming function. -
Push spring clamps until they are in the open position and insert luminaire into cutout. (Fig. 2) Make certain safety wire is completely above luminaire and is not caught between it and mounting surface. (Fig. 3)
Contact Us
Rev Date: V0.2 01/12/2021
4400 Earth City Expy, St. Louis, MO 63045
Tell:866-590-3533
Web: superbrightleds.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>