Attop F8 3.5 Ch RC Helicopter Instruction Manual

: June 6, 2024
: Attop

Table of Contents

Battery Installing
Remote Control
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Attop F8 3.5 Ch RC Helicopter
Instruction Manual

Aircraft Parameters
Aircraft: 195 X 45 X 110 mm
Fuselage weight: 48 g
Aircraft battery: 3.7V 550 mAh
Remote battery: 3 x 1.5V AAA
Aircraft charging time: 60 mins
Flight time: 22 mins
Control frequency: 2.4G Main
motor: 2 x 716
Rear motor: 1 x 612

Helicopter

Balance bar
Rotor propeller
Rear rotor
Landing gear
On/Off switch
Indicator light

Charging via USB cable
Step 1. Connect the provided USB cable to the adapter
Step2. Connect the other end of the USB cable to the battery
Step3. Connect the adapter to the socket. If the indicator of the US8 cable is light in Red, it means charging. The indicator is light in Green when charging completed
Note The connected USB Adapter should be equal to 5V 2A, the ti greater than 5V, otherwise there is a risk of o tag erlonorbr ding the USB cable.
The flight time is about 22 minutes and the charging time is about 60 minutes.

Battery Installing

Insert the battery into a specified position.
to disassembly, pull back to take it out.

Remote Control

Left Stick (Ascend/Descend)
On/Off switch
Control light
One key takeoff/landing
Left rotation trimming
Right Stick (Forward/Backward/Turn left/Turn right)
Right rotation trimming

Syncing

Switch on the helicopter and put it on flat even ground
Switch on the controller
Both indicators on the helicopter and controller will flash while syncing. Push the left stick up and then down to sync. Both indicators will go steady

Ready to Fly
Take Off

Push the left stick up and release to go into Idle mode
The propellers will rotate but the helicopter will not take off.
Press the take-off button, the helicopter will hover a few feet of the ground. Then gently advance the Left stick to a desired height and release. The helicopter will hover at that height :
OR
From Idle mode, gently advance the Left stick up to a desired height and release. The helicopter will hover at that height Landing

Landing

Press the landing button to lower the helicopter to the ground.
OR
Push down on the Left stick until the helicopter is on the ground.
Helicopter operation

Speed Adjustment
Press the Left stick vertically to adjust the speed mode.
When unlocking the helicopter the default speed is a low-speed mode.
Press once vertically and hear 2 beeps to fast speed mode.
Repeat the operation to adjust the speed mode.
Tips: Beginners would be suggested to use the default speed firstly.
to play until skillful.

Dear customers,
We are delighted that you have chosen this faithfully reproduced and high- quality product To ensure that you enjoy your model for a long time, we would ask you to handle your vehicle carefully to avoid damaging delicate parts. To prevent accidental operation of the vehicle, batteries and power packs must be removed from the toy when not in use. We wish you lots of fun playing!

The helicopter does not work?

Is the power switch of the transmitter and helicopter switched to the ‘ON’ position.
Have the batteries been inserted correctly in the transmitter?
Has the device been fully charged?
Are the battery contacts bent or dirty?
Are the batteries discharged or defective?

The helicopter does not work properly; the range is too short?

Is battery/accumulator power fading?

Warning: The manufacturer is not responsible for any radio or television interference that might be caused by unauthorized modifications to this equipment. Modifications of this nature may invalidate the user’s consumer rights.

Precautions (Please retain!)

WARNING! Not suitable for children under 8 years of age. Keep the instructions for use for later reference. Subject to technical change and change of color. Adult help is required to remove the securing devices.
Before first use: read the user’s information together with your child.
Operations and safe use must be explained (preferably by graphical illustrations).
Flying the helicopter shall be used with caution since skill is required in order to control the flight and avoid collisions with the user, objects, or third parties, and children must be trained how to safely fly and control the toy under the direct supervision of an adult.
Note for adult supervisors: Check if the toy is assembled as instructed. The assembly shall be performed under the supervision of an adult.
Do not touch the rotating rotor, avoid loose clothing or hair that could be caught in the rotor, do not fly near the face. Hands, hair, and loose clothes shall be kept away from the propeller (rotor).
Do not change or modify anything on the helicopter!
For safe use, the room where the toy is used must sufficiently large. The room must be free from obstacles.
This toy is intended to be used in domestic areas (house and garden) only.
Caution! Do not start up and fly when persons, animals, or any obstruction are within the flying range of the helicopter to keep the toy in line of sight maximum operating distance. (30m)
Caution: Risk of eye injuries! Do not fly near your face to avoid injuries.
Never lift the helicopter up while the propeller is still turning.
To prevent accidental operation of the helicopter, batteries and power packs must be removed from the toy when not in use.
To avoid accidental operation the transmitter must be switched on before the helicopter. When switching off, always switch the helicopter off and then the transmitter.
Wires are not to be inserted into socket outlets.
We are not responsible for any loss of data, or damage to software, or other damage to computers or accessories caused by battery charging.
Check to charge unit regularly for damage. In case of damage, the charging unit must not be used until it has been fully repaired. The charging procedure must only be undertaken in dry areas; protect the unit from damp.
Warning. Adult assembly required. Using incorrect means to assemble the parts, incorrectly dis-assembled the parts which are not allowed to be disassembled, it would cause electrical hazards, thermal hazards, laceration injuries, and other mechanical and physical hazards. The included screwdriver is only used by an adult, keep this screwdriver away from children. The included screwdriver is only allowed to be used for re-installation of the blades of the rotor and the batteries cover according to the assembly instructions and is not allowed to be used for other parts. The re-installation, assembly of the blades of the rotor is allowed by adults only. The use of the assembly tools for this product (re-installation of the spare blades) must follow the instructions. Other modifications and disassembly of other parts of the product (copter and remote controller) and incorrect use of the tool are prohibited. Replacement by other screws and fixings are not allowed.
The toy is only to be connected to Class II equipment bearing the following symbol.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

this device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.