TESLA TSL-TRV-GS361A Smart Thermostatic Valve Style User Manual
- June 5, 2024
- Tesla
Table of Contents
TSL-TRV-GS361A
Tesla Smart TRV Style
User Manual
Overview
Radiator Thermostat (GS361-H04), using a dry battery power supply, without wiring, easy installation, for the temperature control of warm water radiator, provide comfortable temperature, reduce energy waste, save the cost of heating users. This product has a built-in Zigbee® (Tuya) wireless communication module with low power and an LCD display screen. It can be used individually and can be added to the Tesla Smart APP to make it an intelligent thermostat. After joining the Tesla Smart system, you can select the mode, set the temperature, set the child lock, and set the window detection function in APP. Any operation at the device side will also be synchronized to APP, such as setting temperature manually.
Features
- 3 mode settings—Automatic mode (For future), Manual mode, and Anti-freezing mode.
- Temperature settings range from 5~30°C(For Automatic mode and Manual mode) or 5~15°C(For Anti-freezing mode).
- With an LCD display screen and big characters, easy to see.
- Battery life depends on networking or not. (1~2 years for networking, 2~3 years for using alone)
- zigbee® wireless communication protocol is safe, reliable, and convenient.
- Easy to join TeslaSmart intelligent system
Illustration
- LCD display screen
- Knob / Press: Setting mode / Rotate: Adjusting temperature
- Interface nut
- Fault
- Low battery
- Temperature you set
- Window Detection
- Automatic mode
- Manual mode
- Installation mode
- Networking
- Child lock
Installation Instruction
4.1 Put in the battery
-
Turn the outer case towards the arrow with the right hand and pull out.
-
Referring to the polarity direction of the battery compartment, put in 2 AA alkaline batteries.
Note that cannot use rechargeable batteries. -
After putting it into the batteries, the current temperature and symbol will be displayed.
-
Load the outer case and turn it in the opposite direction with a right hand to complete the installation of batteries.
4.2 Start to use
You can use your thermostat in only a few steps.
-
Press the knob and hold on for 3 seconds before the product is installed on the valve.
-
Until the appears and the symbol flickers, there will be slight vibration at the same time.
-
Align the thermostat interface nuts to the radiator valve. Then push forward slightly and turn the interface nuts clockwise until tightening. The maximum torque
is 5N·m. -
Press the knob again and appears.
-
After about 10 seconds, the symbol disappears and the current temperature is displayed.
The installation is finished.
In order to minimize the influence of the radiator‘s own heat on the thermostat, it is recommended to install it as follows.
4.3 Automatic detection
- When the thermostat is installed, the equipment will be adjusted automatically according to the heating system. During this process, you may find that the thermostat is a slow response or self-heating / self-cooling. This is normal and is a necessary part of the adjustment process.
- Thethermostatwillclosetheradiatorvalveataspecifictime, and then opens it again to detect the exact opening position of the valve. The automatic detection function can make use of heat as efficiently as possible and control the temperature more accurately.
- If necessary, please reload the battery and activate the installation mode and manually run the automatic detection function.
4.4 About valve
Installation diagram of valve A.
Installation diagram of valve B.
Operation instruction
5.1 Select mode locally
In standby status, press the button to switch to three modes: Automatic,
Manual, and Anti-freezing.
• Automatic mode (For future)
In automatic mode, the thermostat automatically switches to the required
temperature, such as set at 21°C when being home, set at 17°C when sleeping,
and set at 15 °C when being away home. The automatic mode needs to connect to
the gateway and needs a network.
• Manual mode, this temperature you set will not change because of the
different situation mode. the temperature can be set manually by adjusting the
knob and the temperature range is 5~30°C.
•Anti-freezing mode
In anti-freezing mode, while you leave home for a long time, set the
thermostat as an anti-freezing mode with a range of 5~15°C. This mode is
mainly designed to protect water pipes from freezing at low temperatures.
5.2 Set temperature locally
Under the standby status, turn around the knob can adjust the temperature
after pressing the knob.
5.3 Set child lock locally
Long press the thermostat knob to turn on or close the child lock function, as
shown in the following figure. When the child lock function enables, all
operations on the thermostat will be invalid to prevent children from playing
with the thermostat or misoperation because of curiosity.
Note that setting child lock locally must be done after installation.
- Press the knob and hold on for more than 3 seconds.
- A symbol appears to indicate that the child lock has been enabled. Repeated operation 1 will un-enable the child lock function.
5.4 Installation of Tesla Smart APP
Scan the QR code as below, and get and install Tesla Smart APP for IOS and
Android systems.
Tesla Smart APP
5.5 Set gateway of Tesla Smart
After installing Tesla Smart APP, it is necessary to operate the network
setting of the Tesla Smart ZigBee Hub.
- Login to the APP after registration
- Click ‘Add Device’
- Select ‘Tesla Smart ZigBee Hub’
- Make sure the LED is always on and click to next
- Wait until the next Interface appears
- Finished
5.6 Add into Tesla Smart
In standby mode, the thermostat will enter the matching mode by pressing the
knob three times quickly.
The matching process is limited to 2 minutes, cannot be interrupted halfway,
and then automatically withdrawn.
- Click ‘Add sub device’
- Find out ‘Thermostat’ and click it to match.
- Click the knob 3 times quickly.
- Wait until next
- Successfully Interface appears
- Main page
5.7 Mode selection in APP
It supports switching Automatic mode, Manual mode, and Anti-freezing mode in
APP. Please refer to the introduction of section 5.1 for the differences
between different modes. 
5.8 Set temperature in APP
The temperature settings in different modes are supported in APP, and the
operation can be accomplished by dragging the adjusting ball simply. (Drag the
adjusting ball to set the temperature.)
5.9 Set child lock in APP
Child lock can be enabled or canceled by APP, as shown in the following
figure. When the child lock function is enabled, all operations on the
thermostat will be invalid to prevent children from playing with the
thermostat or misoperation because of curiosity.
Click on the window button to enable or cancel the window detection function.
5.10 Setwindowdetection
The window detection function can be enabled or canceled by APP, as shown in
the following figure. When the window opening detection function is enabled,
if the thermostat detects that the window is opened, the valve will be closed
for 30 minutes to reduce heat loss. The window detection function is opened by
default. If it has been shut down, it can be reopened according to the
following steps.
Click on the valve button to enable or cancel the valve detection function.
5.11 Set valve detection
The valve detection function can be turned on or off by APP, as shown in the
following figure. When the valve detection function is opened, when necessary,
it will run its own valve inspection procedures. The valve detection function
is opened by default. If it has been shut down, it can be reopened according
to the following steps Click on the valve button to enable or cancel the valve
detection function.
5.12 Automatic Mode Settings
- Click the button
- Click ‘Add timing’
- Set the time and temperature and save.
- Save successfully and click ‘Back’.
- Finished
Technical Specifications
| Power input | DC3V(AAx2 A Ikalinity |
|---|---|
| Standby current | Without network 5100 p A Networking 5120 p A |
| Maximum current | S 8 0 0 mA |
| Bluetooth version | ZigBee ® |
Wireless distance of 30 meters in an open-air
Setting temperature| Automatic mode 5–30 C°
Manual mode 5–30 C°
Anti-freezing mode 5–15 C°
Measurement intervals| Once every 2 minutes.
Valve stroke| 6 mm is the longest
Noise level| < 30dB(A)
Environment| -20 65 C°, 59570RH Noncondensate
Environmental standards| RoHS
Size| 0 57x89mm
W eight| –192g Include batteries
Statement
The information in the User‘s Manual is absolutely correct at the time of
publication, however, we are not responsible for the application of this
document. The application mentioned in this document is for illustration
purposes only. We do not guarantee or represent that these applications
without further modifications are appropriate and that we also have the right
to modify the product without any notice. For the latest information, please
refer to our website http://www.teslasmart.com.
INFORMATION ABOUT DISPOSAL AND RECYCLING
This product is marked with the symbol for a separate collection. The product
must be disposed of in accordance with the regulations for disposal of
electrical and electronic equipment (Directive 2012/19/EU on waste electrical
and electronic equipment). Disposal together with regular municipal waste is
prohibited. Dispose of all electrical and electronic products in accordance
with all local and European regulations at the designated collection points
which hold the appropriate authorization and certification in line with the
local and legislative regulations. Correct disposal and recycling help to
minimize impacts on the environment and human health. Further information
regarding disposal can be obtained from the vendor, authorized service center,
or local authorities.
EU DECLARATION OF CONFORMITY
Hereby, Witty, s.r.o declares that the radio equipment type TSL-TRV-GS361A is
in compliance with EU directives. The full text of the EU declaration of
conformity is available at the following internet address:
teslasmart.com/declaration
Connectivity: ZigBee IEEE 802.15.4
Frequency band: 2.400 – 2.480 GHz
Max. radio-frequency power (EIRP): < 20 dBm
Manufacturer
Tesla Global Limited
121 Des Voeux Road Central
852 00 Hong Kong
www.teslasmart.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>