HAMRON 016047 Light Bar LED Instruction Manual
- June 4, 2024
- HAMRON
Table of Contents
Item 016047
LIGHT BAR LED
OPERATING INSTRUCTIONS
Important! Read the user instructions carefully before use. Save them for
future reference.
(Translation of the original instructions).
SAFETY INSTRUCTIONS
- Read these instructions carefully before installation and save them for future reference.
- Always comply with the applicable laws and regulations for the installation and use of auxiliary headlights.
| Read the instructions.
---|---
| Approved in accordance with the relevant directives.
| Recycle discarded products in accordance with local regulations.
TECHNICAL DATA
| Rated voltage | 9 — 36 VDC |
|---|---|
| Light source | 12 x5 W LED |
| Output | 60 W |
| Luminous flux | 5400 Im |
| Color temperature | 6000 K |
| Range | 1 lux at 401 m |
| Range | 0.25 lux at 766 m |
| Protection rating | IP68 |
| Cord length | 50 cm |
| E-approved | Yes |
| ETM* | Yes |
| Size | W358 x H40.5 x D52.5 mm |
| Weight | 11 kg |
DESCRIPTION
Slim extra lighting that makes driving safer and less tiring. Harmon’s slim
light bar produces a more discrete impression and a stylish look. There are 12
x 5 WLED light sources that deliver 5400 theoretical lumen and 4590 actual
lumen. The beam Is a so-called Spot beam, which means that the light bar
produces a powerful spot beam a long way ahead on the road. LED light sources
to have electronic thermal monitoring (ETM), which retains the intensity of
the diodes and avoids discoloring if the heat becomes excessive. Adapter for
fixed installation and mounted on the supplied bottom or side fasteners made
of stainless steel. Installation accessories and DT connector included.
FIG, 1
BEAM
- Diffusion angle
- Metres
FIG. 2
ETM
Thanks to Electronic Thermal Management (ETM) the intensity of the diodes is maintained and discoloring is avoided if the heat becomes excessive.
INSTALLATION
-
Disconnect the negative/chassis earth cable from the battery before connecting the product, to avoid damage from short-circuiting during the installation.
-
Follow as far as possible the existing cable routing for the installation of new cables. Carefully fasten the cable and any excess length with cable ties, insulating tape or the equivalent. Cable grommets through the firewall should be at a safe distance from moving parts.
-
Drill screw holes with a diameter of
8.5 mm in the surface where the product is to be installed. -
The product can be mounted with side (1) or bottom (2) fasteners. Put the screws in the holes, put on the lock washers and tighten the nuts.
FIG. 3
Cable color coding
The DT connector’s red wire is (+) and the black wire is (-).
WARNING!
- The product must only be used within its rated voltage range, 9 to 36 VDC.
- The light source gets hot when the product is switched on. Allow the light source to cool for at least 30 minutes before touching or handling it.
- Make sure there is a free flow of air through the cooling fins on the light source and keep the fins clean.
Care for the environment!
Recycle discarded products in accordance with local regulations.
Jula reserves the right to make changes. For latest version of operating
instructions, see www,jula.com JULA AB, BOX 363,
SE-532 24 SKARA
2022-02-18
© Jula AB
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>