CRYSTORAMA 5085-PB-CL-MWP Traditional Crystal 5 Light Clear Crystal Chandelier Instruction Manual
- October 30, 2023
- CRYSTORAMA
Table of Contents
LIGHTING THE WAY FOR SIXTY YEARS
ASSEMBLY INSTRUCTION MODEL #5085-PB-CL-MWP
Crystal Sets
A. 35 Sets. (1)14mm + AS9-2″
B. 1 Piece. (2)14mm + AS8-40mm Ball
C. 10 Sets. (15)14mm
DETAILED ILLUSTRATION
All electrical components must be installed by a licensed electrician in accordance with the National Electric Code and the appropriate local elecrical codes
You will need 5- Candelabra Base Bulb 40 Watts recommended 60 Watts Max. USE LED BULBS FOR EXTENDED USE
The fixture is Dry rated
HOW TO INSTALL:
- Screw the Center column kit onto the distributor box.
- Place the bottom bowl, check ring, bobeche, check ring,in that order, over the bottom distributor box. Secure with the finial.
- To install the glass arms, slightly loosen each screw on the top plate over the distributor box. Pull a female plug through a hole in the plate. Connect the male plug at the end of the armwith the female plug that was just pulled. Push the end of the arm with the metal tab through the hole until stopped by the metal tab(this should also push the wires and plugs back inside the metal plate). Twist the metal tab counter-clock wise until both inserts lock onto the loose screws. Tighten the screw securing the arm in place. Repeat for all arms.
- Attach the mounting bar onto the outlet box.
- Decide the desired hanging height and adjust the chain to the correct length.
- Raise the fixture up and do the wire connection. Attach the canopy over the mounting bar and secure with collar ring.
- Dress the crystals as illustrated.
WARING: This product can expose you to Lead, which is known to the State of California to cause cancer and/or birth defects or reproductive harm.For more information go to www.p65warnings.ca.gov
Part Number
Part Numbers
A. (2)-Wire Connector
B. (1)-Mounting Bar
C. (1)-Lock Washer
D. (1)-Hex Nut
E. (1)-Nipple
F. (1)-Canopy (W5″xH1″)-XSN5080PBCAN5IN
G. (1)-Collar Ring
H. (1)-Collar Loop
I. (1)-Chain (4mmx72″)-XSN5080PBCHA4MM
J. (1)-Center Column Kit Loop
K. (1)-Center Column Kit
Top Bowl ; Ø6″,10pin,14mm center hole.
Glass Vase x 2pieces; H5″
Metal Cover;Ø1″,H2″
L. (6)-Bobeche ; Ø4″,5pin,24mm center hole.
-XSN5080PBBOB5PN
M. (5)-PVC Candle Sleeve
N. (5)-8″ Arms with holder-XSN503GDARM8INKD
O. (5)-Male Plug
P. (1)-Distributor Box
Q. (1)-Bottom Bowl ; Ø6″, no pin,14mm center hole.
R. (2)-Check Ring ; Ø1 3/8″
S. (1)-Finial-XSN5080PBFIN