HIFONICS TS250R Bassreflex Subwoofer Systems Instruction Manual
- June 9, 2024
- HIFONICS
Table of Contents
HIFONICS TS250R Bassreflex Subwoofer Systems
IMPORTANT NOTES
Choose a suitable location for your sound system, that neither the driver’s field of vision nor the security of the inmates will be affected. This stands also for airbag-zones and safety belts. The permanent temperature of the location should not be lower than 5°C and not higher than 50°C. Protect the device from moisture and humidity
Ensure that your subwoofer enclosure will not get loose during the drive and hurt someone in the passenger cabin. It is recommended, that you mount the subwoofer enclosure with suitable belts or any other mounting solutions in the trunk area.
Please observe not to damage any serial components of your vehicle (air bags, wires, gas tank etc.) during the installation of your sound system by drilling or any other operations.
Never screw or mount any other devices (amps, caps etc.) onto the subwoofer enclosure, this may cause damage to the electricity
For your personal concerns you should choose a appropriate sound level for the subwoofer enclosure, that neither the roadworthy of the driver nor his concentration will be disturbed, that he is able to notice possible traffic noises and acoustical warning signals.
Modern car audio sound systems provide very high acoustic pressure beyond the 100 dB mark. Please observe in this case, that permanent use of high sound levels may cause damage to your ability of hearing.
Please ensure by any means the correct polarity of all connections. Faulty installed and connected devices may get damage the vehicle and the device permanently.
Please check in any case the operation guide or wiring manual of your amplifier which you’d like to use for the sound system.
Never connect the speaker terminals with the 12 Volt power supply, otherwise the speakers may get damaged
POWER RATING
The HiFONICS TITAN TS subwoofer enclosures are designed for high bass levels. Anyhow it is possible, that unsatisfying sound characteristics could be caused by too low or too high amplifier power. In certain circumstances this even can cause a damage to the loudspeakers.
It is recommended to choose rather a more powerful amplifier (ca. 15-20% more Watts RMS than the max. RMS power rating of the woofer) and to use the amplifier not at the maximum output level (low distortion factor, good sound characteristics). A weaker amplifier at the maximum level causes worse sound characteristics due to the higher distortion factor.
Never crank up the output volume of your amplifier to the maximum level or run the amplifier into the clipping range. If the sound is distorted and not clean, turn back the level until the distortions disappear.
Please note the following recommended power ratings:
TS250R
One Amplifier with approx. 240 to 360 Watts RMS @ 4 Ohms.
TS300R
One Amplifier with approx. 300 to 500 Watts RMS @ 4 Ohms.
The HiFONICS TITAN TS subwoofer enclosures have no integrated limiter orclipper, which is limiting the level upwards. Overamplified bass peaks leads inevitably to a burn out of the voice coil of the woofer. A burn out of the voice coil, caused by clipping/overamping is not covered by the usual warranty
INTERCONNECTION
Please ensure that the connection of the cables have the correct polarity.
NOTE
Before you start with the installation of the sound system, disconnect necessarily the GROUND connection wire from the battery to avoid any risk of electric shocks and short circuits.
Customer
Audio Design GmbH
Am Breilingsweg 3 · D-76709 Kronau/Germany
Tel. +49 7253 – 9465-0 · Fax +49 7253 – 946510
www.audiodesign.de ·
www.hifonics.de
© Audio Design GmbH, All Rights Reserved
Documents / Resources
|
HIFONICS TS250R Bassreflex Subwoofer
Systems
[pdf] Instruction Manual
TS250R Bassreflex Subwoofer Systems, TS250R, Bassreflex Subwoofer Systems,
Subwoofer Systems
---|---
|
HIFONICS TS250R Bassreflex Subwoofer
Systems
[pdf] User Manual
TS250R, TS300R, TS250R Bassreflex Subwoofer Systems, TS250R, Bassreflex
Subwoofer Systems, Subwoofer Systems
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>