HAMRON 017345 LED List Instruction Manual
- June 6, 2024
- HAMRON
Table of Contents
HAMRON 017345 LED List
OPERATING INSTRUCTIONS
Important! Read the user instructions carefully before use. Save them for
future reference.
Jula reserves the right to make changes. In the event of problems, please
contact our customer service. www.jula.com
For latest version of operating instructions, see
www.jula.com
Care for the environment!
Must not be discarded with household waste! This product contains electrical or electronic components that should be recycled. Leave the product for recycling at the designated station e.g. the local authority’s recycling station.
SAFETY INSTRUCTIONS SYMBOLS
| Read the instructions.
---|---
| Approved in accordance with the relevant directives.
****| Recycle end-of-life product in accordance with local regulations.
TECHNICAL DATA
- Rated voltage: 5 V
- Output: 2.5 W
DESCRIPTION
- A. LED strip with USB port and IR sensor
- B. Remote control FIG. 1
- A. ON
- B. OFF
- C. Increase the brightness in one-colour mode, or increase the speed in flashing, strobe and fade mode.
- D. Reduce the brightness in one-colour mode, or reduce the speed in flashing, strobe and fade mode.
- E. FLASH – flashing mode. Each colour flashes rapidly.
- F. STROBE – strobe mode. Change of colour every 3 seconds.
- G. FADE – fade mode. The colours slowly fade into each other.
- H. SMOOTH – rapid fade mode. More rapid colour fading than in fade mode.
- I. Colour selection – choose between 16 colours with adjustable brightness. FIG. 2
BEFORE INSTALLATION
When necessary LED strip (A) can be cut to the required length, along the white dotted lines. FIG. 3
INSTALLATION
- Check that the installation surface is smooth, clean and dry.
- Check that the LED strip (A) reaches up to the USB port.
- Remove the protective film (1) from the back of the LED strip.
- Put the LED strip against the surface and press in place for a few seconds. FIG. 4
CONNECTION
Connect the LED strip (A) to the USB port. FIG. 5