MEEC TOOLS 012172 USB Charger Instruction Manual

MEEC TOOLS 012172 USB Charger

SAFETY INSTRUCTIONS

• The product must only be used for its intended purpose and in accordance with these instructions. All other use is considered to be unsuitable.
• The manufacturer cannot accept liability for personal injury or material damage resulting from improper use of the product.
• The product is intended for household use and must not be used for commercial purposes. The warranty will be invalidated if the product is used for commercial purposes.
• The manufacturer cannot accept liability for personal injury or material damage resulting from improper use of the product. Store the product in a dry place out of the reach of children.

NOTE: Do not point the beam from the LED at people or animals.

CHARGING

Make sure to do the charging in a suitable place and that the right charger is used. Never connect an unknown charger, or a charger, charging cable or battery that can be suspected to be defective. otherwise there is a risk of overheating, and in the worst case fire. Do not leave the battery unattended when charging.

SYMBOLS

TECHNICAL DATA

• Voltage 18 V
• USB ports 2x
• USB port 5 V, 2A

DESCRIPTION

1. LED lamp
2. Switch
3. Belt clip
4. USB connection
5. Battery adapter
6. Status light

USE

INTENDED USE
The battery adapter is used together with rechargeable batteries in the MEEC 18 V series as a charger station or voltage source via the 2 USB ports. The battery adapter can be used to illuminate the surrounding area with the built­in LED. The light can be switched off.

HOWTOUSE
Put the battery adapter on a charged battery so that it clicks in place.

LED lighting

1. Press the switch to activate the battery adapter. The status light flashes 4 times and then stays on.
2. Press the switch once again to switch on the LED. The status light stays on to show that the power supply is on.
3. Press the switch again to switch off the LED. The status light fades out.

Using a USB device

1. Connect the required USB device with a suitable cable to a USB port on the battery adapter.
2. Press the switch to activate the battery adapter. The status light flashes 4 times and then stays on. The status light stays on to show that the power supply is on. The connected device is supplied with voltage from the battery adapter to charge or use.
3. Press the switch for about 2 seconds to switch off the USB port. The LED flashes and the power supply to the USB device is disconnected. The status light fades out.
4. If the unit is not going to be charged or used, disconnect it from the battery adapter.

MAINTENANCE

CLEANING

• Do not rinse or pour water or any other liquid on the USB charger, or immerse it water or any other liquid – risk of electric shock.
• Use a damp cloth or brush to clean.
• Do not use strong detergent or solvent, this can damage the USB charger.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>