Livex Lighting 17371-35 Rotterdam 10 Tall Bathroom Sconce Instruction Manual
- June 13, 2024
- Livex Lighting
Table of Contents
Livex Lighting 17371-35 Rotterdam 10 Tall Bathroom Sconce
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.
- WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
- ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1).
- Shut off the power at the circuit breaker and remove old fixture from ceiling, including the old mounting plate.
- Carefully unpack new fixture and lay all the parts on a clear surface.
- Attach the mounting plate (A) to the junction box using screws (B). The side of the mounting plate marked “GND” must face out. The junction box is not included.
- While holding the lamp body towards the junction box, guide supply wires through hole in center of mounting plate. Follow wiring instructions carefully (see fig.2).
- Attach the back plate (C) over the mounting plate (A), aligning the 3 holes on the back plate (C) with the 3 threaded holes on the mounting plate (A). Insert the fixture body screws (D) and tighten the fixture body.
- Attach the glass shade (E) and the nut (F) onto the socket of the lamp body, then securely tighten the nut (F) using the wrench (G), then remove the socket wrench and save it.
- Install the light bulb (Not included) in accordance with the fixture specifications.
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
CONNECTING THE WIRES (Fig.2)
- Take the black wire from the junction box and the black wire from the fixture and twist bare ends together. Twist wire connector onto end of wire until snug.
- Repeat same process with white junction box wire and white fixture wire. NOTE: Twist wires together in the same direction you twist the wire connector onto wires.
- If your junction box has a grounding wire (green or bare copper), attach this wire and the bare copper wire from the fixture together as step 1. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the mounting plate.
- Tuck the wire connections neatly into the wall junction box.
Your installation is now complete. Return power to the junction box and test the fixture.
Documents / Resources
|
Livex Lighting 17371-35 Rotterdam 10 Tall Bathroom
Sconce
[pdf] Instruction Manual
17371-35 Rotterdam 10 Tall Bathroom Sconce, 17371-35, Rotterdam 10 Tall
Bathroom Sconce, Tall Bathroom Sconce, Bathroom Sconce, Sconce
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>