Shure Bluetooth Earphones RMCE-BT2 User Manual

RMCE-BT2

Shure Bluetooth ® Earphones

Bluetooth Pairing

1. Turn off the earphones. Press and hold the center button on the earphone remote until the LED flashes blue and red.
2. From your audio source, select “Shure BT2.”
3. When successfully paired, the LED turns blue.

Note: If the pairing fails on the first attempt, repeat the process from the beginning.

For additional pairing methods, please visit http://www.shure.com/earphones.

The best sound starts with a good fit

• Select the sleeve that provides a snug fit (like earplugs).
• Secure the cable behind the ear to maintain a tight seal.

To keep them sounding their best…

• Clean regularly to remove debris and deposits.
• Contact Shure Service and Repair to replace damaged product. Simply detach and return the broken earpiece for easy replacement.

Changing Sleeves

• Gently twist and pull to remove sleeve.
• Install the new sleeve so it completely covers the barb and nozzle.

Visit http://www.shure.com/earphones for replacement parts and important instructions on cleaning and maintenance.

Using the Remote

The Center Button

Up and Down Buttons

Your phone may not be compatible with some functions. Visit http://www.shure.com/earphones for more information.

Charging the Earphones

Red LED indicates low battery.

1. Connect the earphones to a charging device using the supplied USB cable.
2. The LED is red while charging.
3. When fully charged, the LED turns off.

Warning: Before charging, make sure the product is at room temperature, between 10 to 45°C (50 to 113°F).

Note: Use this product only with an agency approved power supply which meets local regulatory requirements (e.g., UL, CSA, VDE, CCC, INMETRO).

Specifications

Antenna Information:

• Type = Chip
• Gain = +1.6 dBi

Bluetooth 5:

• Operating frequency = 2402MHz-2480MHz
• Modulation scheme = FHSS
• RF power = +7.45dBm (E.I.R.P.) (for EU)

Supported Codecs:

• aptX
• aptX HD
• aptX Low Latency
• SBC
• AAC

Safety Information

WARNING

• Follow instructions from manufacturer.
• Product battery may explode or release toxic materials. Risk of fire or burns. Do not open, crush, modify, disassemble, heat above 140°F (60°C), or incinerate.
• Attention should be drawn to the environmental aspects of battery disposal.
• Product shall not be exposed to excessive heat such as sunshine, fire, or the like.
• Do NOT make unauthorized alterations to this product.

Note: Battery replacement to be performed only by Shure authorized service personnel.

CAUTION: Follow applicable laws regarding mobile phone and headphone use while driving.

This product contains magnetic material. Consult your physician on whether this might affect your implantable medical device.

High sound pressure
Hearing damage risk
To prevent possible hearing damage, do not listen at high volume levels for long periods.

Information to the user

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Environmentally friendly disposal

Old electrical appliances must not be disposed of together with the residual waste, but have to be disposed of separately. The disposal at the communal collecting point via private persons is for free. The owner of old appliances is responsible to bring the appliances to these collecting points or to similar collection points. With this little personal effort, you contribute to recycle valuable raw materials and the treatment of toxic substances.

Certifications

Visit http://www.shure.com/earphones for the latest regulatory and compliance information.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking.

This Class B digital apparatus complies with Canadian ICES-003.

Note: Testing is based on the use of supplied and recommended cable types. The use of other than shielded (screened) cable types may degrade EMC performance.

Paraguay Distributor: Microsystems S.R.L., Senador Long 664 c/Dr. Lilio, Asunción, Paraguay

Hereby, Shure Incorporated declares that the radio equipment is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://www.shure.com/europe/compliance

Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: +49-7262-92 49 0
Fax: +49-7262-92 49 11 4
Email: EMEAsupport@shure.de

The Bluetooth word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by Shure Incorporated is under license. Other trademarks and trade names are those of their respective owners.

Qualcomm ® aptX is a product of Qualcomm Technologies, Inc. and/or its subsidiaries.

Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and other countries. aptX is a trademark of Qualcomm Technologies International, Ltd., registered in the United States and other countries.

Shure Bluetooth Earphones RMCE-BT2 User Manual – Optimized PDF
Shure Bluetooth Earphones RMCE-BT2 User Manual – Original PDF

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>