DESIGN MY PALACE INC T-2176 One Piece Toilet Instructions
- June 10, 2024
- DESIGN MY PALACE INC
Table of Contents
**DESIGN MY PALACE INC**
T-2176 One Piece Toilet
Instructions
TOOLS AND MATERIALS REQUIRED
A Water Supply Kit (Not needed if repalcing existing toilet)
B Adjustable Wrench
C Flathead Screwdriver
D Level,
E Nut Driver or Socket Set,
F Putty Knife,
G Tape Measure,
REMOVING YOUR OLD TOILET
- Turn off the water supply.
- Flush the toilet to empty the tank. Remove any water left in the tank or bowl.
- Disconnect the supply line from the tank.
- Remove decorative caps. Unscrew nuts that attach the toilet to the floor.
- Remove toilet.
- Make sure the water supply valve is shut off before installation.
- Remove old closet bolts from closet flange. Clean any old wax, putty, etc. from base area.
IMPORTANT NOTE REGARDING WATER SUPPLY: Before installation ensure that
the shut-off valve is greater than 71/2″ from the center of the drain to the
center of the shut-off valve on either side (Figure 1).
NOTE: This is a true 12″ rough-in toilet from finished wall to center of
the drain (no less than 12″). Baseboard thickness may reduce rough-in
dimension.
ONE PIECE TOILET INSTALLATION PROCEDURE
-
Install new floor bolts into floor flange. (Figure 2)
-
Attach flexible water supply line to the inlet of the fill valve and hand tighten only. At this point, DO NOT connect to the water shut-off valve. (Figure 3)
-
Place a new wax ring around the waste flange of toilet bowl. (Figure 4)
-
Lower the toilet onto the closet bolts, so the bolts project through mounting holes in base Nur of toilet. (Figure 5) Using a rocking motion, press the bowl down to position the toilet onto the flange.
-
Install plastic cap washers, followed by metal washers and nuts onto the closet bolts. (Figure 6) Tighten the bolts alternately until toilet is firmly seated on the floor. CAUTION: DO NOT OVERTIGHTEN NUTS, SEVERE DAMAGE MAY OCCUR
-
Install plastic cap covers.
-
Connect the flexible water supply line (not included) to the shut-off valve. Tighten coupling nut securely (Figure 7).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>