aLora CH316008 Flute 48 Inch Chandelier Instruction Manual
- June 6, 2024
- aLora
Table of Contents
CH316008 Flute 48 Inch Chandelier
Instruction Manual
TECHNICAL SUPPORT
1.833.MY ALORA(692.5672)
technicalsupport@aloralighting.com
WARNINGS AND CAUTIONS
Important: ALWAYS be sure to disconnect power before re-lamping or wiring
the fixture. Read these instructions completely before starting installation.
To avoid the risk of fire and/or shock fixtures must be installed in
compliance to national and local electrical and building codes.
If an existing fixture is being replaced take special notice of which wires
were connected in the outlet box.
DO NOT SEPARATE ANY WIRES THAT MAY BE EXISTING IN THE JUNCTION BOX DO NOT
DAMAGE THE INSULATION OF JUNCTION BOX WIRES.
In Regular circumstances the BLACK wire will be “live”, WHITE will be
“neutral” and GREEN or BARE COPPER will be “ground”. In older buildings, it is
always good practice to reconfirm the polarity of the wiring.
NOTICE
-
The important safeguards and instructions outlined in this sheet cannot cover all possible conditions and situations that may occur. It must be understood that caution and certain care factors must be followed. These instructions are provided for your safety and we highly recommend that a licensed, trained electrician install this unit.
-
This fixture is designed to be mounted on a correctly installed standard round or octagon box OR through a wiring box with a plaster frame. The box must be securely mounted to the structure of the building. The crossbar and hardware supplied should be used, directly mounting the fixture to the outlet box may make it impossible to correctly align the fixture.
ASSEMBLY INSTRUCTIONS
Step 1 Remove the mounting crossbar (1d) from within the canopy (2a) by
loosening the mounting collar (2b). Attach the mounting crossbar (1d) to
junction box (1a), using two junction box screws (1f) (not provided). For
additional support install anchor screws (1c) through crossbar into ceiling
and thread on the supplied finishing nuts (1e). Determine the desired length
the fixture will hang by selecting from the assorted rod sizes supplied (2c).
Slide selected rods through the fixture wires and thread the rod assembly to
the fixture body (3a). Next, Slide the mounting collar (2b) followed by the
canopy (2a) through wire and rods and thread on the fixture pivots (1g)
(figure 1).
Step 2 Cut down the extra wire and slide it through the mounting
crossbar. Connect fixture wires to junction box wires using the barrettes
provided (1b). (white to white “N”, black to black “L”, green to green “G”).
Slide canopy (2a) and mounting collar (2b) towards ceiling and thread on the
mounting collar nuts to the canopy pivots (1f). This will secure the canopy to
the mounting crossbar and ceiling.
Step 3 Install recommended lamps (3c) (not provided) (referred on the
socket label for maximum wattage and type) to fixture sockets (3b). Secure the
glass shades by placing them over lamps (3d) and securing in the shade holders
(3b). Finally, restore power. If the fixture has integrated LED (Lighting
Emitting Diodes) lamp installation is not required
You are now ready to enjoy your fixture.
P. 1.833.MY ALORA (692.5672)
CANADA: 102 19028 27TH
Ave. – Surrey, BC V3Z 5T1
USA: 3035 E.
Lone Mountain Rd – Las
Vegas, NV, 89081
www.aloralighting.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>