alora Edwin LED Wall Sconce Instructions

: June 13, 2024
: aLora

Table of Contents

alora Edwin LED Wall Sconce
Product Information
Product Usage Instructions
ASSEMBLY INSTRUCTIONS
CONTACT
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

alora Edwin LED Wall Sconce

Product Information

Product Name: WV348222 Wall Lamp
Technical Support Contact: 1.855.855.8926
Email: technicalsupport@aloralighting.com.
Manufacturer Address (Canada): 19054 28th Avenue Surrey – BC V3Z 6M3
Manufacturer Address (USA): 3035 E. Lone Mountain Rd – Las Vegas, NV, 89081
Website: www.aloralighting.com
Date: 20230619

Product Usage Instructions

Step 1: Remove the fixture from its original package.
Step 2: Separate the mounting plate (1c) from the canopy (2a) by removing the canopy screws (2b).
Step 3: Attach the mounting plate (1c) to the electrical junction box (1a) using the junction box screws provided (1e) in the hardware package.
Step 4: Make proper electrical connections by connecting the black wire to hot L, white wire to neutral N, and ground wire to GND using the wire nuts (1b) provided in the hardware package. Place the driver (4a) in the electrical junction box (1a).
Step 5: Secure the glass (3b) to the fixture body (3a) by threading it clockwise.
Step 6: Attach the canopy (2a) to the mounting plate (1c) using the canopy screws (2b).

You are now ready to enjoy your wall lamp.

WARNINGS AND CAUTIONS

Make sure POWER is COMPLETELY OFF at the fuse box
Have your fixture installed by a qualified licensed electrician
Prepare everything in a clear area
Wear gloves at all times during this installation
Read instructions carefully before you start assembly
Keep this installation sheet for future reference

Please Note

This Alora LED fixture comes with pre-wired LED module(s)
Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required
120V input

NOTICE

The important safeguards and instructions outlined in this sheet cannot cover all possible conditions and situations that may occur. It must be understood that caution and certain care factors must be followed. These instructions are provided for your safety and we highly recommend that a licensed, trained electrician install this unit.
This fixture is designed to be mounted on a correctly installed standard round or octagon box OR through a wiring box with a plaster frame. The box must be securely mounted to the structure of the building. The crossbar and hardware supplied should be used, directly mounting the fixture to the outlet box may make it impossible to correctly align the fixture.

ASSEMBLY INSTRUCTIONS

alora-Edwin-LED-Wall-Sconce-fig-1

Step 1
Remove fixture from its original package.
Step 2
Separate mounting plate (1c) from canopy (2a) by removing canopy screws (2b).
Step 3
Attach mounting plate (1c) to electrical junction box (1a) using junction box
screws provided (1e) in hardware package.
Step 4
Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in hardware package and place driver (4a) in electrical junction box (1a).
Step 5
Secure glass (3b) to fixture body (3a) by threading clockwise.
Step 6
Attach canopy (2a) to mounting plate (1c) with canopy screws (2b).
You are now ready to enjoy your fixture.