aLora PL307912 Picture Light Instruction Manual
- June 6, 2024
- aLora
Table of Contents
aLora PL307912 Picture Light
TECHNICAL SUPPORT
1.833.MY ALORA(692.5672) technicalsupport@aloralighting.com
WARNINGS AND CAUTIONS
Important: ALWAYS be sure to disconnect power before re-lamping or wiring the
fixture. Read these instructions completely before starting installation.
To avoid the risk of fire and/or shock fixture must be installed in compliance
to national and local electrical and building codes.
If an existing fixture is being replaced take special notice of which wires
were connected in the outlet box.
DO NOT SEPARATE ANY WIRES THAT MAY BE EXISITING IN THE JUNCTION BOX
DO NOT DAMAGE THE INSULATION OF JUNCTION BOX WIRES.
In Regular circumstances the BLACK wire will be “live”, WHITE will be
“neutral” and GREEN or BARE COPPER will be “ground”. In older buildings it is
always good practice to reconfirm the polarity of the wiring.
NOTICE
- The important safeguards and instructions outlined in this sheet cannot cover all possible conditions and situations that may occur. It must be understood that caution and certain care factors must be followed. These instructions are provided for your safety and we highly recommend that a licensed, trained electrician install this unit.
- This fixture is designed to be mounted on a correctly installed standard round or octagon box OR through a wiring box with a plaster frame. The box must be securely mounted to the structure of the building. The crossbar and hardware supplied should be used, directly mounting the fixture to the outlet box may make it impossible to correctly align the fixture.
ASSEMBLY INSTRUCTIONS
Step 1
Remove the mounting plate (1c) from within the canopy (2a) by loosening the
two mounting screws provided (2b). Attach the mounting plate (1c) to the
junction box (1a) using two junction box screws (not provided) (1d).
Step 2
Connect fixture wires to junction box wires using the marrettes provided
(1b)(white to white “N”, black to black “L”, green to green “G”). Now secure
the canopy (2a) to the mounting plate (1c) using the two mounting screws
provided (2b).
Step 3
Install recommended lamps (referred on the socket label for maximum wattage
and type) to fixture socket and restore power. If fixture has integrated LED
(Light Emitting Diodes) lamp installation is not required
Step 4
To adjust the height of the fixture, release the swivel (3a) located at the
canopy and set to desired height. Tighten the swivel to lock the fixture in
place. To adjust the angle of the shade, release the swivel (3b) located at
the top of the shade and set to desired angle. Tighten the swivel to lock the
shade in place.
You are now ready to enjoy your fixture.
P. 1.833.MY ALORA (692.5672)
CANADA : 102 ∙19028 27TH Ave. – Surrey, BC V3Z 5T1 USA : 3035 E. Lone Mountain
Rd – Las Vegas, NV, 89081
www.aloralighting.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>