GE Holiday 60655 Incandescent Miniature Lights User Guide
- June 9, 2024
- GE Holiday
Table of Contents
GE Holiday 60655 Incandescent Miniature Lights User Guide
IMPORTANT SAFETY INSTRUCTIONS
When using electric products basic precautions should always be followed
including the following: a1 READ AND FOLLOW ALL SAFETY INSTRUCTIONS
b) Do not use seasonal products outdoors unless marked suitable for indoor and
outdoor use.
When products are used in outdoor applications, connect the product to a
Ground Fault Circuit Interrupting
(GFCI) outlet. If one is not provided, contact a qualified electrician for
proper installation.
c) This seasonal use product is not intended for permanent installation or
use.
d) Do not mount or place near gas or electric heaters, fireplaces, candles or
other similar sources of heat.
e) Do not secure the wiring of the product with staples or nails, or place on
sharp hooks or nails.
f) Do not let lamps rest on the supply cord or on any wire.
g) Unplug the product when leaving the house, when retiring for the night, or
if left unattended.
h) This is an electric product-not a toy! To avoid risk offire, burns,
personal injury and electric shock it should not be played with or placed
where small children can reach it.
i) Do not use this product for other than its intended use.
j) Do not hang ornaments or other objects from cord, wire, or light string.
k) Do not place lighting string on carpeting,drapes,furniture,or allow ii to
contact vinyl siding while the power is on.
I) Do not perform any maintenance or troubleshoot for bad or broken lamps
while the power is on.
m) Do not close doors or windows on the product or extension cords as this may
damage the wire insulation.
n) Do not cover the product with cloth, paper or any material not part ofthe
product when in use.
o) This product is equipped with push-in type lamps. Do not twist lamps.
p) This product employs overload protection (fuse). A blown fuse indicates an
overload or short-circuit situation.
If the fuse blows, unplug the product from the outlet. Also unplug any
additional strings or products that may be attached to the product. Replace
the fuse as per the user servicing instructions (follow product marking for
proper fuse rating) and check the product. If the replacement fuse blows, a
short-circuit may be present andthe product should be discarded.
q) Read and follow all instructions that are on the product or provided with
the product.
SAVE THESE INSTRUCTIONS
USE AND CARE INSTRUCTIONS
a) When the product is placed on a live tree, the tree should be well
maintained and fresh. Do not place on live trees in which the needles are
brown or break off easily. Keep the tree holder filled with water.
b) If the product is placed on a tree, the tree should be well secured and
stable.
c) Before using or reusing, inspect product carefully. Discard any products
that have cut, damaged, or frayed wire insulation or cords, cracks in the lamp
holders or enclosures, loose connections, or exposed copper wire.
d) When storing the product, carefully remove the product from wherever it is
placed, including trees, branches, or bushes, to avoid any undue strain or
stress on the product conductors, connections, and wires.
e) When not in use, store neatly in a cool, dry location protected from
sunlight.
USER SERVICING INSTRUCTIONS
Fuse replacement:
Most often, fuses blow because too many sets have been strung end-to-end. = al
Before changing fuses, make sure the set is unplugged. ct!ll
b Grasp plug and remove from the receptacle or other outlet device.
Do not unplug by pulling on cord. 11 ,.,
c) Using a flathead screwdriver, open fuse cover. Slide open • ~ the fuse
access cover on top of attachment plug towards blades. dl Remove fuses
carefully.
e Risk of fire. Replace fuse only with 3Amp, 125 Volt fuse (provided with
product). LAMP -~
f Close fuse cover. Slide closed the fuse access cover on top of attachment
plug. sHuNT –
Make sure door is fully closed and fuses are completely covered. socKETg)
Risk of fire. Do not replace attachment plug. Contains a safety device (fuse)
that should not be removed. Discard product if the attachment plug is damaged.
Bulb replacement: Before changing bulbs, make sure set is unplugged. I ij 1
Step 1: Grasp plug and remove from the Step 3: Replace bulb with only 2.5
Volt, • • receptacle or other outlet device. tB f 0.35 Watt regular midget
push-in
Do not unplug by pulling cord. ~1~~- type lamp provided with product. Push ii
Step 2: Hold bulb by the plastic base / spare bulb/base assembly into socket.
.X. nd pull bulb/base straight ~~;s ii Do not twist bulb when inserting into
socket. out of socket. .X. If bulbs are twisted, part of the set will not
light.
If the spare bulbs provided with the product have no plastic base or ~ ~ the
plastic base does not fit, first follow steps 1-2 above. Then ijt I ij a)
Remove the old bulb by straightening the bulb wires and •
pulling bulb straight from the base. I
b) Replace the new bulb by straightening the bulb leads and + aiming each wire
into a separate hole in the plastic base. A B c
C) Make sure each bulb lead comes out an exit opening at the bottom of the
plastic base.
Now bend each lead up such that each bulb lead fits closely against the narrow
side of the plastic base.
CAUTION, 1. This lighting string is rated 67.2Watts (0.56Amps), do not
overload. Connect other or decorative outfits end-to-end up to a maximum of
216 Watts (1.8 Amps)
total. If connecting to ring that does not have a Wattage (W~rating (found on
the tag within 6 inches of the plugj calculate the wattage as follows:
Multiply the current (_A which Is on the flag-type tag by 120.
For examp e: Lighting string is rated 120 V, 60 Hz, 0.56 Amps. 0.56 x 1 0 =
67.2 Watts.
Add the wattage of each light string together for a total of 216 Watts or
less. (Do not exceed 216 Watts.)
2. To reduce the risk of overheating, replace burned-out lamps promptly. Use
2.5 Volt, 0.35 Watt lamps only.
3. To reduce the risk of fire and electric shock: a) Do not install on trees
having needles, leaves or branch coverings of metal or materials which look
like metal, and. b) Do not mount or support strings in a manner that can cut
or damage wire insulation.
For questions and/or assistance, call customer service at
1-877-398-7337 or visit us on the web
at www.geholidaylighting.com.
©2022 Nicolas Holiday Lim~ed., 9F., No.37, Guangfu N Rd., Taipei, Taiwan 10560
All rights reserved.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>