aLora mood WV407618 Wall Vanity Fiore Two Light Installation Guide
- June 1, 2024
- alora mood
Table of Contents
Fiore
WV407618
WV407618 Wall Vanity Fiore Two Light
TECHN I CAL S UPPORT
1.855.855.8926
technicalsupport@aloralighting.com
WARNINGS AND CAUTIONS
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all times during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
· 120V input
NOTICE
- The important safeguards and instructions outlined in this sheet cannot cover all possible conditions and situations that may occur. It must be understood that caution and certain care factors must be followed. These instructions are provided for your safety and we highly recommend that a licensed, trained electrician install this unit.
- This fixture is designed to be mounted on a correctly installed standard round or octagon box OR through a wiring box with a plaster frame. The box must be securely mounted to the structure of the building. The crossbar and hardware supplied should be used, directly mounting the fixture to the outlet box may make it impossible to correctly align the fixture.
ASSEMBLY INSTRUCTIONS
Step 1
Remove fixture from its original package.
Step 2
Separate mounting plate (1c) from canopy (2a) by removing canopy screws (2b).
Step 3
Attach mounting plate (1c) to electrical junction box (1a) using junction box
screws provided (1e) in hardware package.
Step 4
Make proper electrical connections (black to hot “L”, white to neutral “N”,
ground to “GND”) with wire nuts (1b) provided in hardware package.
Step 5
Install the recommended lamp (4a) (not provided) (referred on the socket label
for maximum wattage and type) to fixture socket.
Step 6
Loosen decorative nut (3c) to separate outer cup (3a) and inner cup (3b).
Place inner cup (3b) inside shade (3d) and push outer cup (3a) against shade
(3d) and secure with decorative nut (3c) (See Illustration 1).
Step 7
Attach canopy (2a) to mounting plate (1c) with canopy screws (2b).
You are now ready to enjoy your fixture.
P. 1.855.855.8926
CANADA: 19054 28th Ave., – Surrey, BC V3Z 6M3
USA: 3035 E. Lone Mountain Rd. – Las Vegas, NV 89081
www.aloramood.com
20240109