BEGA 50106.2 Wall Luminaire for Indoor Use Instruction Manual

: June 12, 2024
: BEGA

Table of Contents

Dimension
Application
Product description
Safety
Overvoltage protection
Installation
Cleaning · Maintenance
Replacing the LED module
Spares
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

**BEGA 50106.2 Wall Luminaire for Indoor Use Instruction Manual

**

Dimension

Application

Free-radiating wall wall luminaire · indoor luminaire made of hand-blown opal glass, satin matt and metal housing.

The character of the three-ply opal glass creates a smooth and uniform light distribution in the room.

Product description

Glass holder made of matt brushed aluminium
Hand-blown opal glass, satin matt 2 mounting holes ø 6mm
Distance apart 160 x 32mm
Connection terminal 2.5@
Earth conductor connection
Installation surface 215 x 60 mm
LED module for power supply
Suitable for phase angle or phase section dimming
220-230 V 50/60 Hz
BEGA Thermal Switch®
Temporary thermal shutdown to protect temperature-sensitive components
Safety class I
– Safety mark
– Conformity mark
Weight: 1.2 kg

Safety

The installation and operation of this luminaire are subject to national safety regulations.
Installation and commissioning may only be carried out by a qualified electrician.
The manufacturer accepts no liability for damage caused by improper use or installation. If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.

Overvoltage protection

The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against e.g. transients, etc. we recommend separate overvoltage protection components.
You can find them on our website at www.bega.com.

Lamp

Luminaire connected wattage 20 W
Rated temperature ta=25 °C
Ambient temperature ta max=25 °C

50 106.2K3

Module designation 2x LED-1249/930
Colour temperature 3000 K
Colour rendering index Ra > 90
Module luminous flux 1880 lm
Luminaire luminous flux 1618 lm
Luminaire luminous efficiency 80,9 lm/W

Please note:
If the luminaire is to be mounted onto a metallic, electroconductive surface, it is mandatory to make sure that the mounting surface is connected conductive to the earth conductor of the luminaire!

Installation

LED are high-quality electronic components!
Please avoid touching the light output opening of the LED directly during installation or relamping.

Make earth conductor connection. Push silicone sleeves over the lines and make electrical connection.

Fix glass holder with enclosed or any other suitable fixing material onto the mounting surface.

Place glass with its opening over the LED module and fix it hand tight onto the glass holder by means of the knurled nut

Cleaning · Maintenance

Clean luminaire regularly with solvent-free cleansers from dirt.

Replacing the LED module

The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to those of the modules originally fitted. The module can be replaced by a qualified electrician or a comparably qualified person using standard tools.
Disconnect the system and open the luminaire.
Please follow the installation instructions for the LED module.
Defective glass must be replaced. Close the luminaire.