aLora PD307931 Pendant Instruction Manual
- June 6, 2024
- aLora
Table of Contents
aLora PD307931 Pendant
OVERVIEW
WARNINGS AND CAUTIONS
Important: ALWAYS be sure to disconnect power before re-lamping or wiring the fixture. Read these instructions completely before starting installation. To avoid the risk of fire and/or shock fixtures must be installed in compliance with national and local electrical and building codes. If an existing fixture is being replaced take special notice of which wires were connected in the outlet box.
- DO NOT SEPARATE ANY WIRES THAT MAY BE EXISTING IN THE JUNCTION BOX
- DO NOT DAMAGE THE INSULATION OF JUNCTION BOX WIRES.
In Regular circumstances the BLACK wire will be “live”, WHITE will be “neutral” and GREEN or BARE COPPER will be “ground”. In older buildings, it is always good practice to reconfirm the polarity of the wiring.
NOTICE
- The important safeguards and instructions outlined in this sheet cannot cover all possible conditions and situations that may occur. It must be understood that caution and certain care factors must be followed. These instructions are provided for your safety and we highly recommend that a licensed, trained electrician install this unit.
- This fixture is designed to be mounted on a correctly installed standard round or octagon box OR through a wiring box with a plaster frame. The box must be securely mounted to the structure of the building. The crossbar and hardware supplied should be used, directly mounting the fixture to the outlet box may make it impossible to correctly align the fixture.
ASSEMBLY INSTRUCTIONS
-
Step 1
Determine the desired length the pendant will hang by selecting from the assorted rod sizes supplied (2c). Feed the wire (starting from the bottom) through each rod until you reach the last rod then secure rods to fixture body (3a). Remove the mounting crossbar (1c) from within the canopy (2a) by loosening the mounting collar nut (2b). Slide mounting collar nut (2b) followed by the canopy (2a) through wire and rods. Feed fixture wire through canopy pivot (1e) and mounting crossbar (1c) and thread canopy pivot (1e) to fixture assembly. -
Step 2
Attach mounting crossbar (1c) to junction box (1a), using two junction box screws (1d) (not provided). Cut down the extra wire and connect fixture wires to junction box wires using the barrettes provided (1b). (white to white “N”, black to black “L”, green to green “G”). Slide canopy (2a) and mounting collar nut (2b) towards ceiling and thread on the mounting collar nut (2b). This will secure the canopy to the mounting the crossbar. -
Step 3
Install recommended lamps (referred on the socket label for maximum wattage and type) to fixture socket and restore power. If the fixture has integrated LED (Light Emitting Diodes) lamp installation is not required
You are now ready to enjoy your fixture.
P. 1.833.MY ALORA (692.5672) CANADA: 102 ∙19028 27TH Ave. – Surrey, BC V3Z 5T1 USA: 3035 E. Lone Mountain Rd – Las Vegas, NV, 89081 www.aloralighting.com
TECHNICAL SUPPORT 1.833.MY ALORA(692.5672) technicalsupport@aloralighting.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>