imperii RC Transformer Car Instruction Manual
- June 7, 2024
- imperii electronics
Table of Contents
imperii RC Transformer Car
INSTALLING THE BATTERIES
Open the back cover of the remote and place the two 1 .5 V / AA non-
rechargeable batteries in the correct position before replacing the battery
cover.
Dial the body switch to “ON”, then use the remote control.
Remove the battery from the compartment on the bottom of the car and connect
it to the USB cable to charge through the computer or the USB charger. The
estimated charging time is approximately 2 hours.
2.4 G REMOTE CONTROL TRANSMISSION AND FREQUENCY MODE
A. Turn on the car or the remote control by one of the two switches. As
soon as the other is turned on, the product will automatically connect to the
appropriate frequency.
B. If any external circumstances cause the connection between the devices
to fail through the use of this frequency, turn the power off and on again to
reconnect.
CONTROL INSTRUCTIONS
-
During the ‘vehicle’ state, the ignition switch located under the chassis must be in the ‘ON’ position. When you hear the engine and the sound of the horn, the remote control is ready for use (forward/ backward/ turn right/ turn left). After some time without recording any movement, the sound will stop and will be heard again once the activity is restarted.
-
With the car stopped, press the transformation button to start the car mode change to robot mode. A sound will inform you that the transformation has started.
-
When the vehicle is transformed the ‘robot; the operation of the controls of the remote control will be identical to the ‘vehicle’ mode {forward / backward / right turn/ left turn).
-
With the robot stopped, press the transformation button to start the conversion from robot mode to car mode. A sound will inform you that the transformation has started.
-
When the robot is transformed the ‘vehicle; the operation of the controls of the remote control will be identical to that of the ‘robot’ mode (forward/ backward / turn right/ left turn).
PRECAUTIONS
- Do not use on uneven ground.
- Do not wet.
- Avoid blows.
- Do not store near a heat source.
- At all times supervise the toy when it is in operation.
- Avoid outdoor use at night.
- Remove the batteries when the toy is not going to be used.
INSTALLING THE BATTERIES
- Make sure the power switch is set to OFF.
- Use a screwdriver (not included) to open the battery cover.
- Insert the battery ensuring that it is in the correct position indicated by the polarization markers. If the battery has been removed, properly connect the cables to the battery compartment cables, replace the battery, replace the battery cover, and screw.
- Adult assistance is required.
DANGER
-
Do not throw the batteries into the ground.
They could explode or cause toxic material losses. -
Do not mix new and used batteries.
-
Do not mix batteries of different types such as carbon-zinc with alkaline or rechargeable batteries.
-
It is suggested to use batteries not only of the same type but of the same brand.
-
Small parts of the battery can pose a risk of drowning, so adult supervision is needed for change.
-
Make sure that the batteries are inserted following the indicated polarity to avoid short circuits.
-
Do not leave batteries with little load inside the toy. As soon as you notice that they are missing, replace them with new ones.
-
Do not attempt to recharge non-rechargeable batteries.
-
If a rechargeable battery has been used, remove it from the toy before charging.
-
Adults should monitor batteries during the charging process.
-
Keep this manual near the toy box as it contains important information about the product.
WARNING: Contains small parts that may pose a choking hazard. Product not suitable for children under 3 years.
TECHNICAL SERVICE:http:/lwww.imperiielectronics.com/contactenos
imperii RC Transformer Car Instruction Manual – Download
[optimized]
imperii RC Transformer Car Instruction Manual –
Download
imperii RC Transformer Car Instruction Manual – OCR PDF