Dongguan Qishi Industry AP12 Cookie Magsafe Wireless Charger Instruction Manual
- June 6, 2024
- Dongguan Qishi Industry
Table of Contents
Dongguan Qishi Industry AP12 Cookie Magsafe Wireless Charger
Installation Steps
- Please use qualified AC adapter connect the USB-C power cable. The AC adapter should be 5V 2.0A or 10W above, otherwise insufficient input electric current might cause unstable charging.
- Place the back of the charging device with magnetic attraction function to the product front, will attract eachother, and automatically align the charging position to start charging.
Technical specifications
| Name: | Cookie Magsafe Wireless Charger |
|---|---|
| Standar: | QI |
| Conversion Rate: | >= 75% |
| Input: | 5V/2A & 9V/2.2A |
| Output: | 5W / 7.5W / 10W / 15W(MAX) |
Technical specifications
- Do not pull the power cable hard to avoid the power cable from breaking and falling off.
- Do not disassemble by yourself or throw it into fire or water to avoid short circuit and leakage.
- Do not use in severely high temperature, humidity or corrosive environments ot avoid leakage of electricity due to damage to the circuit.
Frequently asked questions
- Charging is slow. The mobile phone itself or the external receiving coil allows the wireless charging current to be different, or the application running consumers a lot of power when mobile phone is charging. It is recommended to reduce or close the application.
- The phone is charging intermittently. If the charging current is not enough, please use a power adpter with sufficient power 5V 2.0A or 10W above.
- Charging fever. It is normal for the receiving coil or transmitter board to generate heat during wireless charging. If the plate is too warm, take your phone off the plate. The plate may switch off automatically if it is too hot. When the plate has cooled down, try charging again.
- The carger does not work. Do not put metal debris or magnetic cards on the charging area. If the product does not work due to overheating, please take off the phone and wait for cooling down temperature and try charging again.
FCC Warning Statement
Changes Of modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipmenL This
equipment has been tested and found to comply with the limits for a Class 8
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception. which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reoient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference recei ved, including interference that may cause
undesired operation.
RF Exposure: A distance of 15 cm shall be maintained between the antenna and users, and the transmitter may not be co-located with any other transmitter or antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>