OPT7 Aura Underbody Rigid Light Bars 36/48 Inch Kit Installation Guide
- June 6, 2024
- OPT7
Table of Contents
OPT7 Aura Underbody Rigid Light Bars 36/48 Inch Kit Installation Guide
MAIN COMPONENTS
INSTALLATION
STEP 1
Decide where to locate the control box and ensure wiring has enough length for
light bars to be installed in the desired location.
IMPORTANT: The control box must be installed inside the vehicle as it is
not waterproof. Avoid installation areas of the engine bay + heated surfaces.
As shown below, connect all the LED bars to the control box with the included extension cables.
Once connected, plug the control box Cigarette Power Adapter into an available 12 volt charging port.
or connect the positive wire to the fuse tap and connector the open negative
wire to a ground (any metal surface). Then plug the fuse tap into the 10amp
switched fuse.
IMPORTANT: Connecting to more than 10amp will override the kit and cause
early failure, ensure it is 10amps or less!
WARNING: Please ensure that the led bars or strips/control box/wiring all
are mounted in areas that will not exceed 85C or 185F.
STEP 2
Secure Control box in the desired location with Velcro or zip ties.
CONTROL BOX NOT WATERPROOF Ensure the control box is safely and securely
hidden from exposing elements of moisture.
STEP 3
Secure the light bars using the zip ties to tie all the wiring away from
the moving components.
IMPORTANT : The LED connectors are not waterproof. You will need to use
HEAT SHRINK TUBE (not included) or ELECTRICAL TAPE around the LED connectors
to ensure the longevity of the lighting kit.
STEP 4
Using the included E-Z Remote, select your desired color or pattern.
AUX WIRING FOR A DOME/DOOR LIGHT
Please scan to see a detailed instructions on Door Assist Sync or go to https://support.opt-7.com/549690-AURA-Door-Assist-Installation-Guide
OPTIONAL UPGRADE
Upgrade your Aura Original Control Box to the Aura Pro Bluetooth Control Box. All new AURA Pro Bluetooth is App-enabled by a smartphone controller (iOS & Android Compatible).
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing
this product. The Installation Guide is intended as assistance to reduce setup
time. OPT7 Lighting assumes no responsibility for improper installation.
If you are unfamiliar with your vehicle or inexperienced with aftermarket
upgrades, please seek professional assistance.
OPT7 recommends installation for safety and guidance.
Modified installations or installation recommendations not specified by OPT7
Lighting will void the product warranty.
NEED SUPPORT?
Scan for tutorial videos, troubleshooting tips, and more.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>