vtech Lullaby Lights Lamp User Guide

June 7, 2024
vtech

vtech Lullaby Lights Lamp

product

INTRODUCTION

Soothe your baby to sleep with the Lullaby Lights Lamp by VTech®. This magical rotating lamp and light projector is ocean themed for your little one’s enjoyment. As your baby goes to sleep they can watch their ocean friends swim around the lamp, or watch the soft light patterns glow onto the ceiling from the projector.image 1

INCLUDED IN THIS PACKAGE

  • One VTech® Lullaby Lights Lamp
  • One Parent’s Guide

WARNING:
All packing materials, such as tape, plastic sheets, packaging locks, removable tags, cable ties and packaging screws are not part of this toy and should be discarded for your child’s safety.

NOTE: Please keep this Parent’s Guide as it contains important information.

Removing the packaging locks:

image 2

  1. Turn the packaging lock anticlockwise several times.
  2. Pull out and discard the packaging lock.

image 3

  1. Rotate the packaging lock anticlockwise 90 degrees.
  2. Pull out and discard the packaging lock.

BATTERY REMOVAL AND INSTALLATION

Lullaby Lights Lamp

  1. Make sure the unit is turned OFF.
  2. Locate the battery cover on the bottom of the Lullaby Lights Lamp. Use a screwdriver to loosen the screw and open the battery cover.
  3. If used or spent batteries are present, remove these batteries from the unit by pulling up on one end of each battery.
  4. Install 3 AA batteries following the diagram inside the battery box. (The use of new alkaline batteries is recommended for maximum performance).
  5. Replace the battery cover and tighten the screw to secure the battery cover.image 4

Remote Control

  1. Locate the battery cover on the back of the Remote Control. Use a screwdriver to loosen the screw.
  2. If used or spent batteries are present, remove these batteries from the unit by pulling up on one end of each battery.
  3. Install 2 new AAA batteries following the diagram inside the battery box.image 5
  4. Replace the battery cover and tighten the screw to secure.

BATTERY NOTICE

  • Use new alkaline batteries or fully charged NI-MH (Nickel Metalhydride) rechargeable batteries for best performance.
  • Use only batteries of the same or equivalent type as recommended.
  • Do not mix different types of batteries: alkaline, standard (carbonzinc) or rechargeable, or new and used batteries.
  • Do not use damaged batteries.
  • Insert batteries with the correct polarity.
  • Do not short-circuit the battery terminals.
  • Remove exhausted batteries from the toy.
  • Remove batteries during long periods of non-use.
  • Do not dispose of batteries in fire.
  • Do not charge non-rechargeable batteries.
  • Remove rechargeable batteries from the toy before charging (if removable).
  • Rechargeable batteries are only to be charged under adult supervision.

Disposal of batteries and product
The crossed-out wheelie bin symbols on products and batteries, or on their respective packaging, indicates they must not be disposed of in domestic waste as they contain substances that can be damaging to the environment and human health. The chemical symbols Hg, Cd or Pb, where marked, indicate that the battery contains more than the specified value of mercury (Hg), cadmium (Cd) or lead (Pb) set out in Battery Directive (2006/66/EC). The solid bar indicates that the product was placed on the market after 13th August, 2005. Help protect the environment by disposing of your product or batteries responsibly.
For more information, please visit:
www.recycle-more.co.uk
www.recyclenow.com

PRODUCT FEATURES

  1. On/Off Button
    Press the ON/OFF Button to turn the unit on and to hear 3 sing-along songs and 20 soothing melodies. Press the ON/OFF Button again to switch the unit off.

  2. Timer Switch
    Slide the Timer Switch to select the desired shut off time. Once the chosen time has finished, the unit will enter sleep mode. Choose from 10, 20 or 30 minutes.

  3. Volume Buttons
    To adjust the volume, press the Low Volume Button or the High Volume Button.image 8

  4. Night Light Button
    Press the Night Light Button to set the light projector, light up the lamp or to turn off the lights.image 9

  5. Mode Buttons
    There are 3 Mode Buttons; Lullabies, Nature Sounds and White Noise. Press one of the three Mode Buttons to choose a mode of play.image
10

  6. Automatic Shut-Off
    To preserve battery life, the VTech® Lullaby Lights Lamp will automatically power down after the selected time or after it has been paused for 1 minute. The unit can be turned on again by pressing any button or when the sound sensor detects baby’s cry.

  7. Sound Sensor
    The VTech® Lullaby Lights Lamp is equipped with a special sound sensor. Once the selected time setting has ended, the unit will automatically power down. The sensor will reactivate the program when it detects baby’s cry for approximately 4 seconds without interruption. The unit will reactivate and play lullabies and nature sounds.

  8. Remote Control
    The Remote Control can start, pause and control the volume within a 30 feet straight-line distance of the lamp’s Remote Control Sensor. Ensure there  are no obstructions directly between the Remote Control and the lamp’s Remote Control Sensor. The Remote Control is disabled after 12 hours without input.image 11

  9. Remote Control Sensor
    The Lullaby Lights Lamp features a Remote Control Sensor which can receive the signal from the Remote Control.image 12

  10. Reactivating the Unit
    The unit can be reactivated by pressing any button, by using the Remote Control (if used within 12 hours of going into sleep mode) or when the sound sensor is activated by your baby’s cry.
    NOTE:
    This product is in Try me mode in the packaging. After opening the package, the unit will enter its normal mode of play. If the unit repeatedly powers down, we suggest changing the batteries.

ACTIVITIES

  1. Press the ON/OFF Button to turn the unit on. You will hear 3 soothing songs and 20 melodies. The lamp and 4 multi coloured lights will fade in and out slowly with the sounds.image 13

  2. Lullabies Button
    Press the Lullabies Button to hear 3 soothing songs followed by soft melodies. Press the Lullabies Button again to hear the next song or melody. The lamp and 4 multicoloured lights will fade in and out slowly with the sounds.image
14

  3. Nature Sounds Button
    Press the Nature Sounds Button to hear a combination of soothing nature sounds. Press the Nature Sounds Button again to hear the next sound pattern. The lamp and 4 multicoloured lights will fade in and out slowly with the sounds.image 15

  4. White Noise Button
    Press the White Noise Button to hear white noise and other sounds. Press the White Noise Button again to hear the next sound. The lamp and 4 multicoloured lights will fade in and out slowly with the sounds.image
16

  5. Play/Pause Button on the Remote Control
    Press the Play/Pause Button on the Remote Control to pause the sounds. Press it again to restart the sounds. If the unit is reactivated within 1 minute, the sing-along song, melody or soothing sounds will continue. However, if the unit is paused for more than 1 minute, when reactivated you will hear different responses.

  6. Volume Buttons on the Remote Control
    Press the High Volume Button to increase the volume, or press the Low Volume Button to decrease the volume.image 17

  7. Light Control Button on the Remote Control
    Press the Light Control Button to turn just the lamp projection ON. Press it again to turn the light projection OFF and to turn the lamp ON. Press it a third time to turn all of the lights OFF.image 18

MELODY LIST

  1. Brahms – Lullaby
  2. Schubert – Ave Maria
  3. All Through the Night
  4. Mozart – Cradle Song
  5. Chopin – Berceuse, Op 57
  6. Tchaikovsky – Swan Lake Waltz
  7. Chopin – Nocturne op.9 No.2
  8. Brahms – Berceuse
  9. Vivaldi – Four Seasons (Summer)
  10. Pachelbel – Canon In D
  11. Bach – Air on the G String
  12. Beethoven – Minuet in G Major
  13. Schumann – Kinderszenen
  14. Mozart – Piano Sonata No. 10
  15. Peas Porridge Hot
  16. Beethoven – Ode To Joy
  17. Mozart – Marche Turque
  18. Ride a Cock Horse to Banbury Cross
  19. Schumann – Of Foreign Lands and People
  20. Mozart – Piano Sonata No.16
  21. Haydn – Serenade
  22. Beethoven – Moonlight Sonata
  23. Vivaldi – Four Seasons (Winter)
  24. Home Sweet Home
  25. Beautiful Dreamer
  26. Diddle Diddle Dumping
  27. Down By the Riverside
  28. Oats, Peas, Beans and Barley Grow
  29. Debussy – Clair de Lune
  30. Beethoven – Fur Elise
  31. Bach – Cello Suite No. 1 in G Major
  32. Bach – Jesu, Joy of Man’s Desiring
  33. Strauss – Blue Danube Waltz
  34. Hush Little Baby
  35. Cockles & Mussels
  36. Rock A Bye Baby
  37. Bicycle Made for Two
  38. Tchaikovsky – The Nutcracker Suite
  39. Pussy Cat Pussy Cat
  40. There’s Music In The Air

SING-ALONG SONG LYRICS

SONG 1
Sleepy, sleepy, little one,
Now it’s time to slumber on.
SONG 2
Close, close, close, your eyes,
Gently go to sleep.
Sweetly, softly, sweetly, softly.
Baby dreams and dreams.
SONG 3
Watch your sea animal friends,
They are swimming around the light.
Quietly, quietly, you’ll fall asleep.

CARE & MAINTENANCE

  1. Keep the unit clean by wiping it with a slightly damp cloth.
  2. Keep the unit out of direct sunlight and away from any direct heatsource.
  3. Remove the batteries if the unit will not be in use for an extended period of time.
  4. Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.

TROUBLESHOOTING

If for some reason the program/activity stops working, please follow these steps:

  1. Turn the unit OFF.
  2. Interrupt the power supply by removing the batteries.
  3. Let the unit stand for a few minutes, then replace the batteries.
  4. Turn the unit back ON. The unit will now be ready to play with again.
  5. If the product still does not work, install a brand new set of batteries. If the problem persists, please contact our Consumer Services Department and a service representative will be happy to help.

CONSUMER SERVICES
Creating and developing VTech® products is accompanied by a responsibility that we at VTech® take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to call our Consumer Services Department with any problems and/or suggestions that you might have. A service representative will be happy to help you.
UK Customers:
Phone: 0330 678 0149 (from UK) or +44 330 678 0149 (outside UK)
Website: www.vtech.co.uk/support
Australian Customers:
Phone: 1800 862 155
Website: support.vtech.com.au
NZ Customers:
Phone: 0800 400 785
Website: support.vtech.com.au

Product Warranty / Consumer Guarantees
UK Customers:
Read our complete warranty policy online at vtech.co.uk/warranty.
Australian Customers:
VTECH ELECTRONICS (AUSTRALIA) PTY LIMITED – CONSUMER GUARANTEES
Under the Australian Consumer Law, a number of consumer guarantees apply to goods and services supplied by VTech Electronics (Australia) Pty Limited. Please refer to vtech.com.au/consumerguarantees for further information.

Visit our website for more information about our products, downloads, resources and more.
www.vtech.co.uk
www.vtech.com.au

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals