MEEC TOOLS 018336 Hand Held Sandblaster Instruction Manual
- June 6, 2024
- MEEC TOOLS
Table of Contents
HAND-HELD SANDBLASTER
OPERATING INSTRUCTIONS
Important! Read the user instructions carefully before use. Save them for
future reference.
(Translation of the original instructions).
Care for the environment!
Recycle discarded product in accordance with local regulations.
Jula reserves the right to make changes. For latest version of operating
instructions, see www.jula.com
JULA AB, BOX 363, SE-532 24 SKARA
2022-01-31
© Jula AB
SAFETY INSTRUCTIONS
Read the operating instructions carefully before use.
Save them for future reference.
Read these instructions carefully before use. Incorrect use and inadequate maintenance of the product can result in serious personal injury and/or material damage. Read all warnings and instructions carefully before use. Always take basic safety precautions when using compressed air tools to reduce the risk of personal injury.
WARNING:
Never open the blast material bag when the tool is connected to compressed
air.
TECHNICAL DATA
Air connection|
R1/4″
---|---
Air consumption|
100-300 l/min
DESCRIPTION
- Quick-release coupling
- Container for blast material
- Bag for blast material
- Nozzle for internal corners
- Nozzle for edges
- Nozzle for external corners
- Nozzle for general use
USE
Compressed air supply
- Hold the mouth of the nozzle firmly against the workpiece.
- Press the trigger for a few seconds each time. Keep checking the result on the workpiece.
- Switch off by releasing the trigger.
- Disconnect the compressed air supply when you have finished.
NOTE: Shake the tool frequently to make sure the blast material is properly drawn up.
Blasting
- Fill the container with blast material.
- Fit the bag firmly on the tool with supplied clip.
- Fit the required nozzle on the tool.
- 4 nozzles are included. for general use, for edges, for internal and external corners. Use the nozzle that best suits the actual job.
- Connect the air hose to the quick-release coupling on the tool.
- Adjust the air pressure from 5.5 to 6.9 bar, depending on the grain size of the blast material and the required surface finish.
- Never be damaged point the mouth towards persons, animals, delicate objects or anything else that can
- Place the mouth against a scrap piece of metal and press the trigger to feed out any impurities in the feed pipe.
Using the blast template
- Fit the nozzle for general use on the tool.
- Align the required template to the part of the workpiece to be blasted.
- Hold the mouth of the nozzle firmly against the template.
- Carry out the blasting as described in the above steps.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>