MAIWO K3016CL Dual-Bay M.2 NVMe & SATA Docking Station User Manual
- June 5, 2024
- MAIWO
Table of Contents
MAIWO K3016CL Dual-Bay M.2 NVMe & SATA Docking Station
Specification
Product name
MAIWO USB3.2 Gen2 M.2 SSD clone docking with SD card reader
Attention
Check the connector icon and SSD label match before assembling SSD, can not work if assemble wrong SSD
Quick Installation Guide
PC mode (Read and Write)
- External storage
- Insert M.2 SSD to correct SSD slot
- Connect USB cable with docking and PC/NB
- . Connect power type C with docking and AC adapter
- Press power swith one time,power and disks LED will illuminate following
- SD card reader
- Insert SD memory card to slot
- Connect USB cable with docking and PC/NB
- Connect power type C with docking and AC adapter
- Press the power swith one time,then SD LED will illuminate following
Operation Guide
How to set the clone mode
-
* NVMe to SATA:set clone switch as below picture, both key up ,lie to “ON”,then follow up clone operation.
- SATA to NVMe:set clone switch as below picture, both key down,lie to “1” and “2”,then follow up clone operation
- SD to SATA: set clone switch as below picture, one key lie to “O”, one lie to “2”, then follow up clone operation.
- SD to NVMe: set clone switch as below picture,n one key lie to “1”, one lie to “N”, then follow up clone operation.
Clone
- Insert SATA M.2 SSD in the “M.2-SATA” slot, NVMe M.2 SSD in the”M2-NVMe” slot, SD card in the “SD Express”Slot. (Kindly note: Don’t insert the SSD in the wrong position)
- Set clone switch follow as diagrame wanted mode (remark: capacity source =<target)
- Connect USB power cable with AC adapter and power typeC port,power LED illuminate green and disk LEDs illuminate white following
- Press clone button twice ,interval approximate 5s, clone LED 25% will flash blue when start till 100% illuminate,four clone LED areblue when complete
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>