audio pro P5 Compact Portable Wireless Speaker User Manual
- June 6, 2024
- audio pro
Table of Contents
P5
User manual 
© AUDIO PRO AB, SWEDEN. ALL RIGHTS RESERVED.
TRADEMARKS ARE THE PROPERTY OF AUDIO PRO AB, SWEDEN.
Audio Pro AB, Garnisonsgatan 52 SE-254 66 Helsingborg, Sweden
©1978-2020 Audio Pro AB Sweden. Audio Pro®, the Audio Pro logotype, the ‘a’
symbol, and ace-bass® are all registered trademarks of Audio Pro AB, Sweden.
All rights reserved. Audio Pro follows a policy of continuous advancement in
development. Specifications may be changed without notice.
All other products and services mentioned may be trademarks or service marks
of their respective owners.
THIS DOCUMENT CONTAINS INFORMATION THAT IS SUBJECT TO CHANGE WITHOUT NOTICE.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by AUDIO PRO AB is under license. Other trademarks and trade names are those of their respective owners.
FCC
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO
THE FOLLOWING TWO CONDITIONS:
-
THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE.
CAUTION: Risk of explosion if the battery is replaced by an incorrect type. -
THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
WARNING: The batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
MODEL: P5. FCC ID: 2AGNC-P5. IC: 20967-P5.
FCC WARNING
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. however, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference of radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different
FCC/ISED RADIATION EXPOSURE STATEMENT
The equipment complies with FCC/ISED RSS-102 Radiation exposure limits set
forth for uncontrolled environments.
USED
This device complies with ISED-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
REARVIEW
CONTROLS
PAIR
TWS
Play audio on two units at the same time.
-
Keep two units next to each other and PRESS-AND-HOLD their pairing buttons simultaneously until the LED flashes quickly in red light, then release buttons.
-
Choose the master unit by PRESSING ONCE on the pairing button of one unit and then quickly PRESS TWICE on the pairing button of the slave unit.
TWS off
SPECIFICATIONS
Type: Powered portable speaker
Amplifier: Digital Class D amplifier, 10 W + 25 W
Tweeter: 1″ dome
Woofer: 3,2″ custom long throw
Frequency range: 57–20.000 Hz
Crossover frequency: 2000 Hz
Dimensions HxWxD: 97x220x53 mm
Inputs: Bluetooth 5.0 (TWS) + Aux In 3,5 mm stereo
plays audio on two devices at once.
Power consumption: STB / ON: <0.5 W / 1,9 W
Charging: USB-C 5V DC (4 hours to fully charge)
IP: IPX4
The lightning flash with the arrowhead symbol, within an equilateral triangle,
is intended to alert the user to the presence of uninsulated “dangerous
voltage” within the product’s enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the
user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
IMPORTANT SAFETY INSTRUCTIONS
-
Read these instructions.
-
Keep these instructions.
-
Heed all warnings.
-
Follow all instructions.
-
Operating temperature (˚C) 5–40
-
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
-
The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, tablecloths, curtains, etc.
-
Do not install near any heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.
-
Protect the charging cable from being walked on or pinched at the point where they exit from the product.
-
Only use attachments/accessories specified by the manufacturer. 1
-
Unplug this product during lightning storms or when unused for long periods of time.
-
Refer all servicing to qualified service personnel. Servicing is required when the product has been damaged in any way, such as charging cable is damaged, liquid has been spilled or objects have fallen into the product does not operate normally, or has been dropped.
-
Damage Requiring Service Unplug the product from the charging cable and refer servicing to qualified service personnel under the following conditions:
A. When the charging cable is damaged,
B. If liquid has been spilled, or objects have fallen into the product,
C. If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation, D. If the product has been dropped or damaged in any way, and
E. When the product exhibits a distinct change in performance this indicates a need for service. -
Object and Liquid Entry
Never push objects of any kind into the product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. No naked flame sources such as lighted candles etc. should never be placed on the product. -
Batteries
Always consider the environmental issues and follow local regulations when disposing of batteries.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>