MAIWO K1717 USB4 40Gbps M.2 NVMe SSD Enclosure Instructions
- May 15, 2024
- MAIWO
Table of Contents
MAIWO K1717 USB4 40Gbps M.2 NVMe SSD Enclosure
PRODUCT INTRODUCTION
- Product Name MAIWO USB 4.0 Type C 40Gbps to M.2 NVMe SSD Enclosure
- Model No. K1717
- Internal interface Support M Key & B+M Key 2280 M.2 NVMe SSD
- Data transfer interface Type-C (USB4.0)
- Material Aluminum alloy
- Features Data transfer
- OS Windows/Mac OS/Linux When the power is on, the blue light
- Indicator light constantly stays lit. The light flashes when the hard drive is reading or writing data.
Installing the hard drive:
- Press and push in the direction indicted by the arrow on the hard disk enlcosure to slide the drive tray out of the PCBA board.
- Then insert the silicone plug into the corresponding hole.
- Attach the slicone thermal pad to the SSD and then attach th e aluminum strip to the slicone pad.
- Insert the NGFF (M.2) SSD or M.2 NVMe protocol SSD at a 45°angle into the NGFF (M.2) connector on the PCBA board.
- Adjust the silicon plug to secure the SSD. Install the aluminum case and the disk tray of the PCBA board.
Connect it to PC:
After installing the hard drive, put the PCBA board back into the hard drive enclosure. Then connect it to the OC with a type-C data cable.
Note : If you install a hard drive already has data on it, it will apear under ” computer” as a newly added hard drive and can read and write normally. If you install a brand new hard drive, you need to initialize, partition and format the hard drive before use.
New Hard disk format:
View “Computer-Manage-Disk Management” to find the new disk.
Right click the “Disk 1”, then click “New Simple Volume”.
Note : There are two formats when initialization, please choose MBR if your dirve are smaller than 2TB, choose GPT if your drives are larger than 2TB.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>