Solar Lighting DIRECT SLDGS0053-WW Residential Garden Spot Light Instructions
- June 5, 2024
- Solar Lighting DIRECT
Table of Contents
Solar Lighting DIRECT SLDGS0053-WW Residential Garden Spot Light
Instructions
PACKAGING CONTENTS
- 1 x Light Fitting
- 1 x Mounting Spike
- 1 x Pack of Screws
FEATURES
- Day/Night Sensor
- High/Low Brightness Setting
- 8 hours Operation per day
- Spike or Surface-Mount Option
- Adjustable Solar Panel
- Colour –Black
INSTALLATION METHOD
- Remove contents from packaging
- Locate the “ON/OFF” power button on the back of your solar panel
- Press the “ON/OFF” button once, the light will be set at “LOW” level (Dim). Press the button again and the light will be at “HIGH” level (Bright). Press the button a third time and your light will be “OFF”
( Note, your light is packaged & transported with the power button in the “OFF” position).
Spike Mount Installation
Please refer to FIGURE 1 for the below steps
- Attach mounting spike to the bottom of your light fitting
- To assure the panel is receiving maximum sun exposure, adjust the solar panel using the swivel head to face direct sunlight
- Spike your garden light into soil or grass and it is ready for use
IMPORTANT NOTES
- Please ensure you place your solar panel in a location where it can achieve a minimum of 6HRS DIRECT SUNLIGHT
- If you wish for longer illumination throughout the night, switch the light to “LOW” mode
- Be aware that on overcast/cloudy days, the solar panel will still charge. However, not as efficiently as a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified.
- It’s best not to install these lights underneath a street light, porch light etc. because this may stop the automatic daynight sensor triggering and result in your lights not turning on.
TROUBLE SHOOTING
| Phenomenon | Cause | Inspection Method | Solution |
|---|---|---|---|
| Light won’t turn on | Switch hasn’t been turned on | Determine what position the | |
| switch is in | Turn the switch on | ||
| Battery has run flat | Period of rainy or cloudy weather or installation site | ||
| doesn’t provide enough direct sunlight | Charge the light in direct sunlight |
for 1-2 days then check again
The light only stays on for a short amount of time| Low Battery| 1. Bad
installation site for the solar panel
2. Dust or leaves are covering the panel
3. Long period of overcast weather| 1. Charge the battery in direct sunlight
for 1-2 days with the switch off, then check again
2. Clean the solar panel
Battery Failure| 1. Access the light and & replace battery
2. Battery has matured| Contact SLD Customer Service to buy new batteries
Customer Service Number: 1300 135 911 www.solarlightingdirect.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>