Solar Lighting DIRECT SLDBLK-300B Residential Bud Light Kits Instructions
- June 5, 2024
- Solar Lighting DIRECT
Table of Contents
Solar Lighting DIRECT SLDBLK-300B Residential Bud Light Kits Instructions
PACKAGE CONTENTS
- 1 x String lights
- 1 x Remote Solar Panel
- 1 x Ground Mount Spike
FEATURES
- “Plug and Play” Installation
- Built in Photo Electric Cell
- 8-10 hours Operation every day
- Mode Selection Switch for “Flash” or “Constant On” options
- DIY and Easy to Install
- Cable Colour – SLDBLK-300B/R/G – Green
- Cable Colour – SLDBLK-300RGB/W/WW – Transparent
- Spike or Surface Mounting Option for Remote Solar Panel
- Colours Available – Blue OR Green OR Red OR White OR Warm White OR RGB (Red, Green & Blue)
INSTALLATION METHOD
- Remove contents from packaging
- Decide where to situate your lights and mount or spike the solar panel accordingly (Where the light will receive maximum direct sunlight – See “Important Notes” )
- Turn your lights “ON” by depressing the “ON/OFF” button on the solar panel ( Please note: All kits are sent out in the “OFF” position)
- Temporarily cover solar panel with nontransparent surface for testing purposes only (this is so the Day/Night Sensor in the fitting registers as night-time) – If you have turned the light on correctly, the light should illuminate
- Whilst light is on, select desired working mode by pressing the “MODE” button on the solar panel
- Remove the non-transparent surface. Your light is now ready to use
IMPORTANT NOTES
- Please ensure you place your solar panel in a location where it can achieve a minimum of 6HRS DIRECT SUNLIGHT
- Be aware that on overcast/cloudy days, the solar panel will still charge. However, not as efficiently as a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified
- It’s best not to install these lights underneath a street light, porch light etc. because this may stop the automatic day-night sensor triggering and result in your lights not turning on
TROUBLE SHOOTING
| Phenomenon | Cause | Inspection Method | Solution |
|---|---|---|---|
| Light won’t turn o | Switch hasn’t been turned on | Determine what position the | |
| switch is in | Turn the switch on | ||
| Battery has run flat | Period of rainy or cloudy weather or installation site | ||
| doesn’t provide enough direct sunlight | Charge the light in direct sunlight |
for 1-2 days then check again
The light only stays on for a short amount of time| Low Battery| 1. Bad
installation site for the solar panel 2. Dust or leaves are covering the panel
3. Long period of overcast weather| 1. Charge the battery in direct sunlight
for 1-2 days with the switch off, then check again 2. Clean the solar panel
Battery Failure| 1. Access the light and & replace battery 2. Battery has
matured| Contact SLD Customer Service to buy new batteries
Customer Service Number: 1300 135 911
www.solarlightingdirect.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>