Solar Lighting DIRECT SLDBL0094-S1-2.4W Residential Bollards Instructions

June 5, 2024
Solar Lighting DIRECT

Solar Lighting DIRECT LOGO INSTRUCTION GUIDE
Residential Bollards
Model No. SLDBL0094-S1-2.4WSolar Lighting DIRECT SLDBL0094 S1 2 4W
Residential Bollards

FEATURES

  1. Automatic Dusk to Dawn operation
  2. IP44 Waterproof rating
  3. Poly-Carbonate construction

INSTALLATION METHOD

  1. Remove contents from packaging

  2. Place light head upside down. Twist off the solar panel section (Anti-clockwise direction) and locate “ON/OFF” power switchSolar Lighting DIRECT SLDBL0094 S1 2 4W Residential Bollards - FIG 1

  3. Switch button to “ON” to activate battery & controller

  4. Decide on your installation process, either Surface mount using supplied screws or Spike mount. Locate and use the following accessories
    (A) Surface Mount
    Attach the two poles by connecting the ends together (FIGURE 1). Connect the surface mount base on the bottom of the post & using supplied fixings, secure to a solid base (FIGURE 2 )
    (B) Spike Mount
    The spike can be found tucked in the cardboard packaging. Remove spike & re- install surface mount base. Press spike into the underside and spike fitting into your chosen location (FIGURE 3 )Solar Lighting DIRECT SLDBL0094
S1 2 4W Residential Bollards - FIG 2

  5. Remove protective membrane from solar panel & your light is now ready for use

IMPORTANT NOTES

  • Please ensure you place your solar panel in a location where it can achieve a minimum of 6HRS DIRECT SUNLIGHT
  • Be aware that on overcast/cloudy days, the solar panel will still charge. However, not as efficiently as a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified.
  • It’s best not to install these lights underneath a street light, porch light etc. because this may stop the automatic day-night sensor triggering and result in your lights not turning on

TROUBLE SHOOTING

Phenomenon Cause Inspection Method Solution
Light won’t turn on Switch hasn’t been turned
on Determine what position the switch is in on Turn the switch
Battery has run flat Period of rainy or cloudy weather or installation site
doesn’t provide enough direct sunlight Charge the light in direct sunlight

for 1-2 days then check again
The light only stays on for a short amount of time| Low Battery| 1. Bad installation site for the solar panel
2. Dust or leaves are covering the panel
3. Long period of overcast weather| 1. Charge the battery in direct sunlight for 1-2 days with the switch off, then
check again
2. Clean the solar panel
Battery Failure| 1. Access the light and & replace battery
2. Battery has matured| Contact SLD Customer Service to buy
new batteries

Solar Lighting DIRECT SLDBL0094 S1 2 4W Residential Bollards - FIG
3 Customer Service Number: 1300 135 911
www.solarlightingdirect.com.au

Documents / Resources

| Solar Lighting DIRECT SLDBL0094-S1-2.4W Residential Bollards [pdf] Instructions
SLDBL0094-S1-2.4W, Residential Bollards
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Solar Lighting DIRECT User Manuals

Related Manuals