Solar Lighting DIRECT SLDFL0004C-4W-PIR-CW Residential Multi-Purpose Light User Guide

June 5, 2024
Solar Lighting DIRECT

Solar Lighting DIRECT SLDFL0004C-4W-PIR-CW Residential Multi-Purpose

Light

PACKAGING CONTENTS

  • 1 x Light Fitting
  • 1 x Solar Panel
  • 1 x Mounted Bracket 1 x Pole Clamp
  • 1 x Pack of Screws

LIGHTING MODES

ON – Light works Dusk to Dawn via solar panel PIR – Light activates when PIR motion sensor is triggered (See FIGURE 1 for dial diagram)
TIME DIAL- Select short or long length of time light will remain on after last movement is detected (5-40secs) (FIGURE 1)
SENS DIAL – Adjust dial to low or high sensitivity .. of the PIR sensor (FIGURE 1)

INSTALLATION METHOD

  1. Remove contents from the packaging
  2. Locate the “ON/OFF/PIR” power switch on the underside of the fitting and select your desired working mode (Note, your light is packaged & transported with the power switch in the “OFF” position)

ASSEMBLY & INSTALLATION

Light Fitting

  1. Fix mounting plate by drilling 3 holes in selected wall
  2. Using the supplied screws, attach the light fitting by drilling the fitting to the mounting plate (FIGURE 1)
  3. To adjust the angle of the light, turn the swivel head

Solar Panel
If mounting your solar panel on a pole/post:

  1. Connect your solar panel to the metal clamp using the supplied screws (FIGURE 2)
  2. Bring the black clamp base through the metal clamp and tight to the bottom of the pole
  3. Using the screw on the thread of the metal clamp, tighten so the clamp base is hard against the pole (FIGURE 3)IMPORTANT NOTES 
  • Please ensure you place your solar panel in a location where it can achieve a minimum of 6HRS DIRECT SUNLIGHT
  • Be aware that on overcast/ cloudy days, the solar panel will still charge. However, not as efficiently as a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified.
  • It’s best not to install the fitting under a street light, porch light or similar as this may stop the automatic day-night sensor triggering and result in your lights not turning on

TROUBLESHOOTING

Phenomenon Cause Inspection Method Solution
Switch
hasn’t been

turned

| Determine what position the switch is

in

| Turn the switch on
Light won’t| on| |
turn on| | Period of rainy or| Charge the light in direct sunlight for 1-2 days then check again
| Battery| cloudy weather or
| has run| installation site
| flat| doesn’t provide
| | enough direct sunlight
| | | 1. Charge the
| | 1. Bad installation site| battery in direct
| | for the solar panel| sunlight for 1-2
| Low| 2. Dust or leaves are| days with the
The light only| Battery| covering the panel| switch off, then
stays on for a| | 3. Long period of| check again
short amount| | overcast weather| 2. Clean the solar
of time| | | panel
| | 1. Access the light and| Contact SLD
| Battery| & replace battery| Customer Service
| Failure| 2. Battery has| to buy new
| | matured| batteries

Customer Service Number: 1300 135 911

www.solarlightingdirect.com.au 

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Solar Lighting DIRECT User Manuals

Related Manuals