Solar Lighting DIRECT SLDIHN1-BLK-WW Flush Mount LED House Number Instructions

June 5, 2024
Solar Lighting DIRECT

INSTRUCTION GUIDE
Residential Illuminated
House Number
Model No. SLDIHN1-BLK-WW, SLDIHN1-SS-CW, SLDIHN1-SS-WW

PACKAGE CONTENTS

  1. 1 x Light Fitting
  2. 1 x Pack of Mounting Screws

FEATURES

  1. Built in Photo Electric cell
  2. 8-10 hours Operation per day
  3. Flush Wall Mount base
  4. 3 x Numerical sets 0-9 of Vinyl Stickers
  5. 1 x Alphabet set of A-F Vinyl Stickers
  6. Glass Lens
  7. SS – Stainless Steel Finish – Cool or Warm White LED’s
  8. BLK – Black P.C. Finish – Warm White LED’s

INSTALLATION METHOD

  1. Remove contents from packaging
  2. Locate the “ON/OFF” switch and turn light on by setting the ( I,O ) switch on the side of your fitting to ( I ) (FIGURE 1)
  3. Locate desired wall mount installation (ensure the location will receive maximum direct sunlight throughout the day)
    Step 1. Stick adhesive house numbers/letters on the front glass surface
    Step 2. Drill 2 holes of 8mm diameter in the wall 154mm apart from one another (FIGURE 1)
    Step 3. Put 2 plastic anchors in the holes and 2 screws into these anchors leaving the head protruding 10mm from the wall
    Step 4. Mount fitting by hooking it onto the screws (making sure it is stable)

IMPORTANT NOTES

  • Please ensure you place the solar panel in a location where it can achieve a minimum of 6HRS DIRECT SUNLIGHT
  • Be aware that on overcast/cloudy days, the solar panel will still charge. However, not as efficiently as a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified
  • It’s best not to install these lights underneath a street light, porch light etc. because this may stop the automatic daynight sensor triggering and result in your lights not turning on

TROUBLESHOOTING

Phenomenon Cause Inspection Method Solution
Light won’t turn on Switch hasn’t been turned on Determine what position the
switch is in Turn the switch on
Battery has run flat Period of rainy or cloudy weather or installation site
doesn’t provide enough direct sunlight Charge the light in direct

sunlight for 1-2 days then check again
The light only stays on for a short amount of time| Low Battery| 1. Bad installation site for the solar panel
2. Dust or leaves are covering the panel
3. Long period of overcast weather| 1. Charge the battery in direct sunlight for 1-2 days with the switch off, then check again
2. Clean the solar panel
Battery Failure| 1. Access the light and & replace battery
2. Battery has matured| Contact SLD Customer
Service to buy new batteries

Customer Service Number: 1300 135 911
www.solarlightingdirect.com.au

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Solar Lighting DIRECT User Manuals

Related Manuals