CYGNETT CY3936CYMCC ExoMag Cable User Manual
- June 5, 2024
- CYGNETT
Table of Contents
CYGNETT CY3936CYMCC ExoMag Cable
**User Manual**
Charge Your Device
Recharge your device by connecting the USB-C connector into a compatible
USB-C charger, then attaching the wireless charging output onto the back of
your device or MagSafe compatible case. Your device should begin to charge
automatically.
To open the built-in kickstand, firmly press the centre of the kickstand.
Compatible with iPhone 12 and iPhone models that support MagSafe technology. For optimum charge speed, ensure you are using a charger that is capable of outputting 18W.
Product Specifications
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to connect the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Caution
Please read all warnings for your safety and optimal user experience. Please read and follow these instructions carefully and retain for your records.
- Do not disassemble or throw into fire or water.
- Do not expose to extreme weather conditions.
- Do not place close to a magnetic strip or strip card as it could cause magnetic failure.
- Please keep charger a safe distance of at least 80cm from any implantable medical devices to avoid medical device interference.
- This is not a toy and should be kept away from children.
- In the case of the device overheating, please disconnect immediately.
Please note that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Cygnett takes no responsibility for damages caused by incorrect use of its products. Made in China.
Cygnett and the Cygnett logo are trademarks of Cygnett Pty Ltd. Other brands and product names are trademarks or registered trademarks of their respective holders
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
“FCC RF Radiation Exposure Statement Caution: To maintain compliance with the
FCC’s RF exposure guidelines, place the product at least 20cm from nearby
persons.
Cygnett Pty Ltd,
858 Lorimer St, Port Melbourne,
Victoria 3207 Australia
Cygnett USA Inc,
3838 W Carson St,
Ste 220, Torrance, CA 90503
Cygnett UK Limited,
71-75 Shelton St,
London, WC2H 9JQ
Cygnett EU,
Office 2, Goudstraat 65,
2718RD Zoetermeer, The Netherlands
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>